Discuss Urgent question about Vaillant 937 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

Masood

Quickly need to know whether there is a jig available for these so that pipework can be run behind?

Thanks!
 
just edited post cos looked into what snowhead said below wont work..
 
Last edited by a moderator:
from what i remember there are alot of connections on these, coming down from above may not be a good idea?
 
Quickly need to know whether there is a jig available for these so that pipework can be run behind?

Thanks!

are the custs after no lag in the hw or does the house have a big demand. tbh 937s and store combis i find are niether here nor there. the lag can be cured by stickin a combi in the middle of the house where the cylinder was and the demand can be sorted via unvented cylinder.. suppose it depends on what customer can afford..
 
Status
Not open for further replies.

Reply to Urgent question about Vaillant 937 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
302
  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from...
Replies
0
Views
106
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON...
Replies
6
Views
283

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock