S
silvergrowler
I have a tap cartridge I need to replace - Its a 1/4 turn tap and I have the correct replacement part Manufactured by San Marco/SMR from the official spares supplier BUT a normal socket won't fit as the cartridge has just 2 flats rather than being hexagonal and I can't get a spanner across the flats as the tap body completely surrounds the main part of the cartridge only leaving the splines of the spindle outside the body. The body is about 15mm in diameter and the flats take a 12mm spanner
Is there a standard tool for this and if so what is it called and do you know of any suppliers? The local plumbers merchant who I normally get parts from is usually very helpful but wasn't able to help in this case.
The tap is a Franke Verbier which was only available for a short time. Its only about 2 years old.
Is there a standard tool for this and if so what is it called and do you know of any suppliers? The local plumbers merchant who I normally get parts from is usually very helpful but wasn't able to help in this case.
The tap is a Franke Verbier which was only available for a short time. Its only about 2 years old.