no fused spur on boiler

[stokecity]

There is no fused spur next to combi boiler, i assume the boiler, clock and stat are wired to a wiring centre then straight to consumer unit, is this correct?? thanks

 

[Best]

Should then have a fused spur for wiring centre.

 

[SafeGasInstall]

Must be on a three pin plug ?

 

[stokecity]

cant find the spur anywhere? not next to the boiler and not next to consumer unit?

 

[stani]

Where does the wire from the boiler go to?

 

[tipintim]

Is it a conversion of an older system? Have a look in the airing cupboard for the power.

 

[stokecity]

there was a water heater before, have traced the wires as far as i can without moving the furniture, they dissapear under floor boards

 

[tipintim]

if cable goes under floor boards, that sugests boiler is upstairs. Or it can be ground floor floor?
If boiler is upstairs, have a look in the kitchen, sounds like the used the old power supply to water heater/cylinder supply

 

[mcniven]

follow the flex from the boiler lol

 

[Howsie]

Switch circuits off and you'll find what its part of. Probably a well hidden plug.

Sent from my GT-I9100 using Tapatalk

 

[tipintim]

Is it flex that you see going to boiler, or twin and earth flat cable?
A photo would be good, can see what is what to help.

 

[SafeGasInstall]

check electrical consumer unit ! have worked in few jobs where boiler was taking direct to consumer unit

 

[Howsie]

Not unusual that along with the fridge.

Sent from my GT-I9100 using Tapatalk

 

[PlumbBobBob]

my boiler is wired back to the airing cupboard and connected into the honeywell wiring centre with a fused spur powering everything through the wiring centre.

 

[tipintim]

The reason i asked if it was an upgrade, was the last one i seen as described , was wired to the cooker point, that they pinched from the old cylinder feed from the airing cupboard. Lol