Search the forum,

Log In Log Out

Post new thread

Discuss Log In Log Out in the Make a suggestion about the forum in general area at PlumbersForums.net

J

Joeberg1

Messages
9
Logged out an in again no probs. Looked at the courses available and got Ooops We ran into some problems. Not sure if that is a web problem, or its thinks I'm too old 🤔
 
Upvote 0 Downvote

Reply to Log In Log Out in the Make a suggestion about the forum in general area at PlumbersForums.net

Similar plumbing topics

johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
250
exedon2
exedon2
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
250
Chuck
C
Dan
  • Sticky
Australia Morning Thread
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
79
Dan
Dan
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
337
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Blog
Tile Advice
Tiling Standards BS5389
Electrical Advice
British Standards in Tiling BS5389
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock