Discuss Hot and Cold Pipe Repair - Good or Bad? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Messages
- 725
Terrible. Looks like a joiner did it. Why start with the big hole too?
Reply to Hot and Cold Pipe Repair - Good or Bad? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Newest Plumbing Threads
-
How much would you pay for a universal flush valve that enables replacements in under 5 minutes?
- Started by Professor
- Replies: 8
-
Bossing shower waste into soil pipe vs. separate shower waste- Started by CitizenErased
- Replies: 3
-
UK Advice on waste water pump in first floor flat
- Started by kbqwert
- Replies: 3
-
AM18x1 femail to 1/2" hose connector.
- Started by Adaminspace
- Replies: 0
-
Off grid shower and toilet solution needed
- Started by TpXThinnr
- Replies: 5
-
Expansion vessel size unvented hot water
- Started by Matt0029
- Replies: 2
-
Acrylic bath manufacturing standards/dimensions
- Started by Michelle
- Replies: 2