Discuss Boulter Camray oil boiler cuts out but starts if front cover removed - Any ideas? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
L

lodgey47

As title when my Camray starts up it runs for a few seconds then stops. A few more seconds later it starts again then stops again...... and so on. What I've found is if I partly remove the front air tight cover it runs fine with no problems. It was serviced over the summer but can't get the engineer back now until after christmas. The fan is quite, oil pump seems ok, flue isn't blocked, plenty of oil. Any ideas?? Cheers
 
It sounds like burner is being starved of oxygen, it either needs the air increasing on the adjuster, best done with a flue gas analyzer. Or its recycling its own flue gases because the flue seals have gone
 
Could also be the combustion chamber access door joint leaking, has it been off recently.
 
Status
Not open for further replies.

Reply to Boulter Camray oil boiler cuts out but starts if front cover removed - Any ideas? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
474
Back
Top