Discuss Boiler not modulating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
2
Hi,
I'm looking at a British Gas 330 boiler made by Glow-worm. The boiler constantly cycles between flat out and off, rather than modulating as it should. I though it might me a blockage somewhere in the system which was preventing hot water get away so the boiler was going into over heat shut down. I've flushed the system but found little or no sludge. The pump appears to be working normally. The flow temperature never gets above 60 deg C. Essentially the boiler heats the house, but it must be horribly inefficient. Any ideas why it isn't modulating and running normally?

Thanks
peterc
 

Reply to Boiler not modulating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
  • Question
Hi, Not sure if this is the place to post this, but hope some one can help. My Central Heating water temperatures seem to fluctuate a lot, while...
Replies
2
Views
829
I recently had a new 2023 Vaillant ecoTec plus 630 (30kW) system boiler installed along with a Low Loss Header (LLH) in my house. I have 21 rads...
Replies
10
Views
807
B
Issue with boiler short cycling in system with hot water tank. We have an ideal heating logic heat2 h15 boiler which feeds a hot water tank...
Replies
10
Views
1K
    • Like
Hi everyone, Just wanted to share my experience with "upgrading" an S plan setup to Opentherm and Vaillant Control Center (VR66). There are a few...
Replies
1
Views
1K
Hi everyone, I'm looking for some advice please. My system has 5 Drayton Wiser TRVs. There are 8 rads over 3 storeys and a 170l unvented...
Replies
10
Views
2K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock