You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
high
High-A (officially Class High-A, formerly known as Class A-Advanced, and sometimes abbreviated "A+" in writing) is the third-highest level of play in Minor League Baseball in the United States and Canada, below Triple-A and Double-A, and above Low-A. There are currently 30 teams classified at the High-A level, one for each team in Major League Baseball, organized into three leagues: High-A East, High-A Central, and High-A West. As part of the 2021 reorganization of the minor leagues, the three current High-A leagues replaced the Carolina League, Midwest League, and Northwest League, respectively, with the Midwest League having previously been a Low-A League and the Northwest League having previously been a short-season league.
Hi Guys,
I thought I would be best off asking for this one in lieu of the wealth of advice on here.
I have a landlord with a halstead ace high combi, boiler fires and stay on all appearing to run fine, no noise, no over expansion. However when heating is switched on pump runs, fan runs...
Hi
I have been unsuccessfully trying to remove this nut to release the syphon from a high level cistern. The pipe is plastic so I cannot heat up the nut. I have tried freeze it spray which usually works but not on this occasion.
Any ideas?
Came across a few Double check valves failing recently. Washing machine no water errors and outside tap with long hose connected same no water. Remove hose and open tap water flows ok. Re-connect hose ...no water. No blockage, no kink. Replaced washing machine valve to one without check valve...
Hi,
i have the above boiler. Ch been off for 6 moths. Hw activated on demand. With hw on Boiler making a occasional banging noise which seems to be resolved after activating CB and bleeding both ch zones. Now pilot light seems to go out and needs manual relighting. Thinking perhaps air...
bigrinks
Thread
flow
high
light
pilot
pilot light
problem
worcester
Got a customer who has called me in after an absolute nightmare with a cowboy builder and an ex-friend project managing her renovation.
I feel really sorry for her, she was actually crying when explaining what had gone on when I first went round.
Anyway, she has a basin mixer that she really...
Hello,
Around 3-4 weeks ago I noticed the TPV overflow pipe at the back of the house was dripping and the system pressure had increased to 3 bar. I bled the radiators (no trapped air) and then ran off some water from a downstairs radiator. Initially this did the trick and the pressure dropped...
Si_99
Thread
constantly
filling
heating
heating system
highhigh pressure
mains
pressure
problem
system
water
For reasons I won't bore you with I cannot have an unvented system so am looking at having a storage combi installed. My mains has been upgraded to 32mm and when the new boiler is installed the current 15mm running into my house from the mains will be upgraded to 22mm.
My house is a normal...
Paul Hemel
Thread
combi
flow
high
litres
minute
really
setup
showers
which
Getting high emissions on a Baxi 105HE, a full strip down has been carried out but then found that the secondary heat exchanger seal behind the plastic connection had failed and was leaking condense back in to the boiler.
So, I replaced the entire secondary heat exchanger today but still...
My boiler is over pressurising, and venting out of the PRV outside (Continually dropping) I have replaced the PRV and checked the expansion vessel that needed topping up. I did notice that when I had toped up the Expansion vessel that the water gauge when up to the pressure that I had put into...
I currently have a gravity feed system.
In the very near future I am adding a loft extension to my property so the 2 cold water tanks in my London roof will have to be removed.
I seek a plumbing/engineer to visit my property to give me advice and possible options in upgrading my existing...
Homealone
Thread
combi
fed
gravity
gravity fed system
highhigh pressure
london
pressure
property
system
upgrade
The wife in her infinite wisdom has decided she wants a high level cistern. As the standard height is 2.3 ish metres and the room is 1.9 my question is can the flush pie be trimmed this much without affecting the flush too much? The cistern is a 3/6 L dual flush.
The wife in her infinite wisdom has decided she wants a high level cistern. As the standard height is 2.3 ish metres and the room is 1.9 my question is can the flush pie be trimmed this much without affecting the flush too much? The cistern is a 3/6 L dual flush.
Cheers
Hi All,
I have installed a small waterfall basin mixer tap and the water shoots out horizontally when the taps is on full - in any position (hot, cold mixed).
I'm wondering if the tap is knackered or just no good for systems where the pressure is high. If it is the latter then I would say...
Hi everyone, ive just moved into a place and the cold water pressure both upstairs and downstairs is immense to the point where the pipes bang and the hot water pressure upstairs is virtually non existent but fine downstairs. My question is, can I buy a pump to increase the pressure of the hot...
Unregistered
Thread
cold
cold water
downstairs
high
hot
hot water
hot water pressure
pressure
question
upstairs
water
water pressure
Hi, we have really good water pressure where we live. But that in turn has left us with very noisy taps in the bathrooms.
At the moment we have Blade taps from the Bathstore - Blade Basin Mono Mini Mixer | bathstore. They have aerators but our water certainly isn't aerated. The taps are...
cmitch
Thread
basin
bath
bathroom
bathstore
blade
highhigh pressure
kitchen
kitchen sink
pressure
sink
sinks
tap
water
hi guys been to service a vaillant today in an empty house, co2 levels fine in the 9's co and ppm were sky high, co over 3000
ive checked over flue (onlyhozontal), seal ect seem fine, can it be a prob with gas valve?? it pretty much blew my fga up, as after it wouldnt register co at all. left it...
Hi guys I am Rob and new on this forum, hope someone can shed some light on my very strange issue. Thanks in advance to all the replies.
I seem to us around 6 to 7 cubic meters per month. But in October that doubled to nearly 16 cubic meters.
The funny thing is I went on holidays from the...
hi guys. got call to above boiler today for routine service. as soon as started to analyse it the readings were off the scale was going up to 5000 pm before removing my analyser. i checked for flue integrity and was getting over 600 pm. gas inlet pressure at full rate was 19mbar. its a vertical...
Hello everyone,
Hopefully you could share your knowledge on this problem or any advice would be appreciated:
The pressure started to drop gradually over the past 2 weeks, but now drops from 1.5bar to 0.3 in 5-8hrs.
So I fill up (fillng loop) to 1.5bar to switch on the central heating and the...
Servicing the boiler, want to know how to check CO readings, Ratio etc
it it says in the manual you can via a plastic cap somewhere, it's an oldish boiler.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.