Discuss After drain, must add inhibitor? in the USA area at PlumbersForums.net

Boiler is designed to work quite happily without inhibitor, however the inhibitor does improve properties of water to prevent sludge, rust and increase its thermal efficiency so seen as a worthwhile thing to add to keep your system in good condition.
 
You are worrying too much. Some advocate no inhibitor, many don’t have it for similar reasons to yours. If you are concerned, drain and refill with a dose of inhibitor.
My concern is, after drained the system, the gas engineer did not add inhibitor. I learned that it is a must to add inhibitor once drained the system.
 
I'd be posting on the gas forum if I were the OP. "New boiler installed this August. No certification!?"
I meant, there's no Gas Boiler System Commission Checklist, but I did receive an email for Certificate of Registration from boiler brand Bosh----is this Certificate of Registration you meant for certification?
 
I meant, there's no Gas Boiler System Commission Checklist, but I did receive an email for Certificate of Registration from boiler brand Bosh----is this Certificate of Registration you meant for certification?
My understanding is there should be a document other than manufacturer registration. That said, as I don't install boilers myself and I'm stuck abroad, rules may have changed without my knowing it. In fairness it does seem odd that an installer could register an installation with Bosch and not have at least pretended to have worked to the Benchmark code of practice, but I'm not sure which is why I suggested posting the specific question on the gas forum.
 
My understanding is there should be a document other than manufacturer registration. That said, as I don't install boilers myself and I'm stuck abroad, rules may have changed without my knowing it. In fairness it does seem odd that an installer could register an installation with Bosch and not have at least pretended to have worked to the Benchmark code of practice, but I'm not sure which is why I suggested posting the specific question on the gas forum.
Thank you for your query and doubt!

I went specially to find the Gas Certificate I have and checked online, it is indeed the boiler installation certificate.
But on the certificate it does not say any specific thing like boiler installation certificate, even not mention boiler or any work done. So I had thought it was my gas hob installation which the installer told me to get the certificate for me. The gas hob and boiler installed at similar time.

Now, after I checked online, I found I have NO gas hob installation certificate!

Thank you again for doubting the certificate which made me find out what I actually have!
 

Reply to After drain, must add inhibitor? in the USA area at PlumbersForums.net

Similar plumbing topics

Hi, I want to add inhibitor into towel radiator for the heating system. I saw from Youtube that people normally open the radiator vent plug from...
Replies
11
Views
1K
A bit of history first. 2 yrs ago visited a grant boiler with boiler and pipework kettling. I added SentX200 noise reducer. It is standard open...
Replies
7
Views
773
Advice please. I drained my open system to add x800 a couple of weeks ago and all ran smoothly. Last night I drained it all out, cleaned the tank...
Replies
28
Views
4K
Hi, I have a sealed system with 18 Rads/towel rads which is run by a greenstar boiler with a sealed hot water tank. I'm using a tado thermostat...
Replies
19
Views
2K
Dear forum, I've an open (gravity) CH system supplying radiators only (AGA does the HW separately). It's a Vaillant Ecotec 435 installed 2018...
Replies
3
Views
688
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock