Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Thermal imager- What do you use? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

999

Gas Engineer
Messages
83
Anyone use a thermal imager in there job?
interested to here whats good given the cost of these units
 
I'm looking at getting one myself and to me the Flir1 looks like a good bit of kit. There are a few plumbers engineers on Twitter who use them and get good results. Not a bad price either.
 
belting bit of kit though I could check which rads were full of sludge and how well they were circulating, I even found a blockage in a zone valve has its outdoor uses too.
 
At that price im confident its well and truely up to the job, im looking at anything thats mentioned but unfortunately i wont be spending that sort of money, the wife would have something to say ;)
 
They are great fun and in the right circumstances work like magic but unless you specialise in leak detection and thermal surveys you may find it is difficult to make one earn its keep.

They have the same calibration issue as contactless spot-temperature probes, i.e. different materials have different albedos. Also, get one that allows you to superimpose visible and thermal images easily. Without this it's difficult to figure out what you're looking at.

You can hire them for ca £75 per day or twice that per week if you have a job that you think needs one. I'd strongly recommend doing this before buying one as the novelty factor soon wears off and they ain't exactly cheap.
 

Reply to Thermal imager- What do you use? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

    • Like
  • Sticky
We have 2 brand new cordless, battery powered press tools in stock, and flying off the shelves. Our TekTools TZ1930 & TZ1550 are packed with...
Replies
5
Views
974
Can anyone recommend a decent multi meter, preferably under a 100 pounds. It's for checking boiler components so I don't need a top spec one...
Replies
7
Views
292
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic...
Replies
2
Views
301
B
    • Friendly
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper...
Replies
2
Views
207
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
227
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock