Discuss Into wanted, outdoor sensor fitting on VIESSMANN 100 30KW B1KC in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
2
Hi, I'm fitting an outdoor sensor on my VIESSMANN 100 30KW B1KC. The wiring is finished, just need to know can I fit the wires any way around or is there a specific way to the 3 and 4 terminals connected to the sensor.

Anyone know?

Cheers
 
Doesn't matter
 

Reply to Into wanted, outdoor sensor fitting on VIESSMANN 100 30KW B1KC in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
323
We have an all Vaillant setup - an EcoTEC Plus 637 system boiler plus wired VR720 and VR92 SensoCOMFORT controller, driving two CH zones plus DHW...
Replies
4
Views
595
Morning, I have a job later this week with the above , Viessmann Vitodens System boiler. It has a 4 pipe setup with internal diverter and at...
Replies
4
Views
537
D
hello! while saving up for a new plumbing and heating installation for my new one bedroom flat, i did a lot of research on different boilers and...
2 3 4 5 6
Replies
51
Views
4K
Hi all, Does anyone have any feedback as to which is best. Running the pipe from the outdoor gas meter to a new boiler on an outside wall or run...
Replies
15
Views
1K

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock