Search the forum,

Discuss Planning permission for underground oil tank in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Matt06

Gas Engineer
Messages
146
Hello, Do you need planning permission to install an oil tank underground?

Planning portal says

Installing a fuel tank is considered to be permitted development, not needing planning permission, subject to the following limits and conditions:

  • Not more than 3,500 litres capacity.
  • Not forward of the principal elevation fronting a highway.
  • Maximum overall height of three metres.
  • Maximum height 2.5 metres within two metres of a boundary.
  • Not more than half the area of land around the "original house"* would be covered by additions or other buildings.
  • In National Parks, the Broads, Areas of Outstanding Natural Beauty and World Heritage Sites the maximum area to be covered by buildings, enclosures, containers and pools more than 20 metres from house to be limited to 10 square metres.
  • Not at the side of properties on designated land*.
  • Within the curtilage of listed buildings any container will require planning permission.

Thanks
 
best ask as planners and environment agency can get quite shirty with underground storage in certain areas, ie close to watercourse, springs etc, its not worth getting it wrong, esp if your watertable is fairly high in your area. You may well have noted that none of what you quoted mentions underground oil stores, which are considered to be other engineering works, if the planners cant find a place for them elsewhere in their rules.
 
Thanks I told them they need planning permission and to get a Tank installation company if they really wanted the tank underground tbh when they get a quote I'm sure they will change their mind
 
large concrete slab and banding to hold it in the ground isnt cheap
 
Piece of cake ! Been there done that many times we had a septic tank that started floating out !
Full of water and a sump pipe with a 6 inch pump running too , had the dam poclain on the neck of the bottle holding it down ,luckily the concrete plant was just down the road and the first driver diverted another load straight to us he saved the day but 12 metres of concrete to hold a bottle in was a dear job !!!!!
 
They have come back to me asking for a quote to either commission or supply and commission an above ground oil tank

Not too sure about just commissioning what do you guys think is a good price just to commission if any one wants to PM i know it would just be an idea. It is Affinity water by the looks of the email or someone that works for them using their work email address. I might go have a look anyway as I am fairly new to oil.

Thanks
 
Try to get to site while they are doing the sub base too, that way you know that it's been done right, rather than just some slabs dropped onto an inch of type 1...
 
Status
Not open for further replies.

Reply to Planning permission for underground oil tank in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
232
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
228
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock