A
aligorgon
hi had abit of an issue with one of the above boilers in a childrens home,
the boiler has 2 burners the bottom one is fine but the top one is giving out off the scale co when istuck myfga in it.
took about an hr to purge the sensors afterwards.
i managed to get the lo fire from over 10k ppm down to the 20,s with the air/gas set screw but the hi fire mode wont come below 10k ppm. its a room sealed flue but i ID'd it anyway and capped gas to appliance.
they have hot water via andrews so its not too much of a worry at this time of yr but i was wondering i anyone else had come up againtst this issue with said boiler?
technical line you say... tried a multitude of times and failed to get through...
the boiler has 2 burners the bottom one is fine but the top one is giving out off the scale co when istuck myfga in it.
took about an hr to purge the sensors afterwards.
i managed to get the lo fire from over 10k ppm down to the 20,s with the air/gas set screw but the hi fire mode wont come below 10k ppm. its a room sealed flue but i ID'd it anyway and capped gas to appliance.
they have hot water via andrews so its not too much of a worry at this time of yr but i was wondering i anyone else had come up againtst this issue with said boiler?
technical line you say... tried a multitude of times and failed to get through...