Search the forum,

Discuss Electric heat only boiler installation advice for a charity please in the USA area at PlumbersForums.net

Mr fibble, to be honest, if you new what you were doing you wouldn't be on here.

People trying to help and you get arsey.
 
Are you basing that on heating to domestic comfort levels? We don’t require that sort of temperature to be maintained.

room temp of 18dc at -10dc outside
 
no would need two at the min
so min 100 amps just for them

I’m struggling with that calculation, on the basis that a 12KW boiler is sufficient to heat a 3 bedroom house in real world tests?
[automerge]1578692462[/automerge]
Here’s the old oil burning plant. Does anyone fancy recommissioning it? We will also need a tank if it’s to run on oil.
 

Attachments

  • A1F5A52C-B420-42F7-930E-7C8594D5A657.jpeg
    A1F5A52C-B420-42F7-930E-7C8594D5A657.jpeg
    122.3 KB · Views: 13
  • BCD1E23F-BA35-4492-935A-A1B86B288E84.jpeg
    BCD1E23F-BA35-4492-935A-A1B86B288E84.jpeg
    149.7 KB · Views: 15
  • 5B760F71-9D03-4604-90E9-000567D292EF.jpeg
    5B760F71-9D03-4604-90E9-000567D292EF.jpeg
    106.6 KB · Views: 13
  • 86EC2C07-60BB-4A05-A3A6-5B82375B10D3.jpeg
    86EC2C07-60BB-4A05-A3A6-5B82375B10D3.jpeg
    96.6 KB · Views: 13
Last edited:
Mr Flibble,

If you are looking for a low level of heat what about an air source heat pump either air to water or air to water to warm air.

I appreciate that the costing side may look high at first glance - but there is quite an extensive array of grants and Govt. funded support available to at least look at the feasibility of a scheme.

Lowcarbondorset advise Charities on the support available for such ideas. They only cover Dorset, but could probably direct you to a sister organisation that covers your area. They very knowledgeable of both the funding available and how to capture it.

We recently installed a secondhand 13KW ASHP, driving a ducted air system for a charity in Kings Langley. The design was to heat an archive of training records to 15 degrees.
 
you should be able to get a lpg air handling unit and fit it into the existing system best contact a hvac company
 
you should be able to get a lpg air handling unit and fit it into the existing system best contact a hvac company

I doubt any of them will be interested in dealing with us, they weren’t particularly keen when we were previously in a different building with HVAC.
Unless anyone has any recommendations?
We are located between Cambridge and the A1M.
[automerge]1578695067[/automerge]
Garbutt Heaters Ltd unfortunately appears to be defunct.
 
Last edited:
That looks like an old Nu Way Selectos burner, don't see many of them about now. Unfortunately, although I have a good understanding of commercial and industrial oil burners I don't have the experience with them I would like. If you're going to go down that route I suggest looking for a guy or firm that have experience with these older units, you're nowhere near me so I cant recommend anyone but there will be some out there that have the knowledge you need.
 
That looks like an old Nu Way Selectos burner, don't see many of them about now. Unfortunately, although I have a good understanding of commercial and industrial oil burners I don't have the experience with them I would like. If you're going to go down that route I suggest looking for a guy or firm that have experience with these older units, you're nowhere near me so I cant recommend anyone but there will be some out there that have the knowledge you need.
Thank you but we’re not intending to recommission the oil burner. Based on what’s missing combined with the safety and insurance aspects, it’s not viable.

The question is as @ShaunCorbs states above, if that burner unit can be replaced with one which heats indirectly by LPG?
I fear that in the time we have left to make the building usable, this will be difficult or impossible to accomplish.
 
Thank you but we’re not intending to recommission the oil burner. Based on what’s missing combined with the safety and insurance aspects, it’s not viable.

The question is as @ShaunCorbs states above, if that burner unit can be replaced with one which heats indirectly by LPG?
I fear that in the time we have left to make the building usable, this will be difficult or impossible to accomplish.

Honestly I wouldn't know. It is as you say an indirect warm air heater, clearly you know the difference between direct and indirect but I couldn't say whether an LPG conversion is possible.
You are however in a perfect position to make a fresh start, whichever route you choose to take.
Again just to illiterate you're asking on a forum with many specialist, you will always get multiple suggestions.
ShaunCorbs has done the math for you, which takes time, so you know what the KW required is to heat this space and the required KW input is.
Whatever the route you take this will be a nice install, I do however suggest you search for the right firm whatever route you take.
 

Reply to Electric heat only boiler installation advice for a charity please in the USA area at PlumbersForums.net

Similar plumbing topics

We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
440
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock