Discuss Atag 203c heat exchanger in the Plumbing Jobs | The Job-board area at PlumbersForums.net

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,171
Hi. I have been to this boiler today which said it needed the pressure topping up. Did it and called out again 3hrs later.

Topped up again and watched the condensate and it drips often when cold.

Anyone else had experience of these heat cells leaking.

Cheers
 
Hi. I have been to this boiler today which said it needed the pressure topping up. Did it and called out again 3hrs later.

Topped up again and watched the condensate and it drips often when cold.

Anyone else had experience of these heat cells leaking.

Cheers
Nope but heard they can do. Let me m ow how you get on.
 
10 year warranty on hex isnt there?

atag commercial 1268 546700
 
This is on the Wolseley site

18B7F4D5-747A-4FB3-A203-454739FECF01.png
 

Reply to Atag 203c heat exchanger in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi everyone, I have taken out the heat exchanger because a tiny leak was found around the red gasket at the top of the heat exchanger of a...
Replies
1
Views
486
Hi, Boiler is losing pressure, from 1.5 bar to 0 bar in about 4 hours. Have checked all rads and seem to be fine, no water out external prv...
Replies
5
Views
668
Hi all not a plumber but am an engineer I have pressure drop in the system Worcester Bosch came back after repressureising the expansion vessel...
Replies
2
Views
514
I have been facing central heating low pressure on unvented hot water RM Cylinders but can't see any leak on the PRV, expansion vessels and...
Replies
2
Views
519
losing pressure
L
Hi All, Have a peculiar problem with my Gloworm Flexicom 30cx combi boiler, the main heat exchanger is getting red hot and fault coding on...
Replies
21
Views
2K
Back
Top