You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
start
STart was a computer magazine covering the Atari ST published from Summer 1986 through April/May 1991—42 issues total. STart began as sections of Atari 8-bit family magazine Antic, before being spun off into a separate publication. Primary competitor ST-Log was similarly spawned by ANALOG Computing. Each issue of STart included a cover disk.
how do i get in to gas works what category am I (1.2.3)
im willing to learn dont do much plumbing
iv worked with a plumber on first fix and gas pipe work
Hi everyone, Hope this thread is ok being posted in here instead of another section.
I have a plan in place and it is as follows,
While I am working weekends to gain experience, I am thinking I should get myself GSR, get my 3 services and 1 install completed to get signed off as competent by...
hi everyone......as much info as possible from your wise and experienced minds would be greatly appreciated....
so heres my current situation.....
im in college doing part time evenings for my level 2.......
i work a full time job earning just above minimum wage.....
baby on the way so i cant...
hi forum, i got laid off last week after 2 years with a gas engineer... on a positive note i have got all my gas hours signed off for my level 3, and i gained heaps of experience... however, the only work i can find at the moment is second fix work on site (I start next week) ... this will be...
Hi,
Been to a job today with gravity hot water and pumped central heating. When the heating is switched on the pump runs for 5 minutes or so then stops. I have removed the vent screw to check its actually running. I thought there may be a problem with the programmer so i have disconnected the...
owington
Thread
after
back boiler
boiler
minutes
oil
pump
replacing
start
oldish ferroli tempera, all good when running, customer has no issues but on start up its sounds like its going to jump off the wall.. done the usual bleeding extra but why this only when cold i.e morning start up and early evening start up... anyone got a ideas ?
Ive just taken an apprentice for the first time on a couple of weeks trial. He's only 16 and has done his first 6 weeks at Guildford college. He has shown me his lovely pictures of bending and soldering but I'm afraid my daily routine is way over what he has been taught. I've been constantly...
cookey
Thread
apprentice
asking
changed
college
start
taken
things
worried
We had a Bristan Artisan recessed shower fitted over a year ago and since installation it will not start the pump when switched on. We have to turn a hot tap on at the basin to get the pump to kick into life.
The pump feeds a bath mixer tap, a basin mixer tap and the shower. Both the bath and...
Morning,
The temperature of the hot water in out immersion tank is very inconsistant, the stat on the tank is sat at 60 and the boiler is a condensing unit, do thermostats 'break' or can they operate in an inconsistant way?
Sometimes the water heats up in the way you would expect IE you can...
rob.quick
Thread
cylinder
degrees
hot
hot water
morning
start
temperature
water
Here is the link to a free start up guide from Business Gateway. Although this is the Scottish version, it contains information that will help ANY new business get off the ground.
Start-Up Guide
I have a problem with my boiler in my house its a ferroli domicompact f30 b, whilst running hot water it will run hot for a few minutes and go cold for a few seconds and go hot again it repeats this cycle at all dhw outlets any ideas im an installer so dont know really where to start??
Hello Everyone,
My first post hope I don't break any rules! but I am seeking advice on my wet under floor heating system which is about 6 years old in a new build of that age.
The system comprises of Camray 5 external oil fired boiler, circulating pump mounted on the boiler, basic temperature...
Highlandeagle
Thread
actuators
advice
failing
floor
heating
needed
power
start
system
terminal
under
under floor heating
which
Hello All,
I've just visted a property where the down stairs rads dont heat up.
Here are the facts
1- two level property 11 rads, mostly single convectors
2- sealed system with two, two port valves and indirect cylinder up stairs
3- boiler downstairs directly underneath
4- boiler Suprima 70HE...
Wasnt sure where to post this. I Thought in here would be as gd a place as any.
What do u all have/use?
Built in cages? Welded padlocks to the outside?
When I buy my van I will defo be fitting some added security, my work van has had the locks knackered a few times by what looks like a...
Hi,
Had our new worcester 30si boiler installed about 3 months ago (havent moved in yet due to renovations, the boiler was tested and was working fine with the old radiators) Since then we have put in new radiators and went to start up the system. The pilot light failed to come on and the...
boggysmoggy
Thread
boiler
light
oil
pilot
pilot light
start
system
timer
Hi i am new to forum, i am gas safe but i don't have many experience on boiler fault finding really!
My brother have a raveheat rsf 82e combi boiler. He says he starts central heating, all radiators get really hot, later boiler lock out, and when he reset and start again lock out in couple of...
Hi, I installed a salamander pump well over a year ago to help boost our hot water. It has worked well although noisier than I would have liked. Recently it has begun starting up all on its own!! It goes on for about 10 seconds and then turns itself off. This is in the bedroom so wakes us...
hello wondering if anyone has any ideas on this please, any advice would help:
i have just moved and have a glowworm fuelsaver ufb 60f, it cuts in and out far to quickly,
The burner lights, all fires up and cuts out when up to temprature, before the fan even has a chance to stop spinning it...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.