Discuss Combi boiler, hot water but no heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Well as its working for hot water that means your Pump is OK, these did have problems with the control panel, but other things need to be checked on heating side not allowed to go into to much detail ! what did the other people check when they looked at your boiler ??
I’m not sure what was checked, other than three different options, I’ve purchased a new control panel which should be here Monday, if that doesn’t fix it then I’ll replace the bluetooth thermostat.
 
i have an Ideal Espirit 2 boiler, the water is working perfect but the heating is not working.
We had a new pump fitted about 12 months ago, I've had three tradesman in and they have all said sometime different; one said I needed a new pump the other said I needed a new programmer and the third said I needed a new boiler.
I'm sick of being ripped off, can someone please let me know if they have any idea what the problem could be
Thank you

Sounds like external controls at fault. Simple test is to pull message wires out and put a link in. If programmer/stat at fault, your boiler should now run constantly on a heating demand
 
I knew there was something I didn’t do
I’ve bought a new control panel which I’ll fit Monday and see what happens.
I’ll post the results

FYI you need to be gas safe ;)
 
I’ve fitted the new itime programmer and still no heating :mad:
Next step replace the Bluetooth thermostat, does it have to be a specific thermostat or can I buy any one?
 
I do not think that the timer you have shown is Bluetooth? Do you have a receiver to go with the thermostat. If so can you post a picture. Cannot remember what you said in you previous posts.
 
Think what he has is a RF room stat not Bluetooth ! why is he messing around replacing parts that may not be faulty, any decent engineer can soon tell if the RF unit the problem,
 
Think what he has is a RF room stat not Bluetooth ! why is he messing around replacing parts that may not be faulty, any decent engineer can soon tell if the RF unit the problem,
That’s where I was getting. To mate. Probably external controls all along as somebody said in a previous post.
 
Status
Not open for further replies.

Reply to Combi boiler, hot water but no heating in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
287
Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no...
Replies
6
Views
261
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
217
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
392
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
281
PSxxxxxx
P

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock