Vaillant Plus 831 v Ideal Vogue Logic Plus 40KW v Worcester Si Compact 30 KW

[Ermintrude]

Check valve is built into the filling loop assembly as supplied by ideal and meets all water regs.

Vogue updates either done in factory or by ideal once registered. Free of charge!

Get Flue clip sorted and turn boiler off until its safe!

It's illegal to leave un commissioned gas appliance connected to gas supply!

 

[naut2k0]

Hey Zebedy, boiler was off and unconnected. The sparky is doing all the electrics now.

So he has found an Ideal Vogue (which was ruddy hard) as they seem in hard demand and Ideal don't like to ship them out via courier as they are getting damaged. It arrives tomorrow.

In the meantime, here are some pics from behind the boiler showing the bracket and the flue (I guess the same flue will work on the Vogue) and the pipework too.

 

[Ermintrude]

Yeh vogue and logic same flue system. Pipe work same at bottom I think.

The daylight coming through behind the bracket is a bit of a problem though. Wall should be made good inside and out. Not permitted to have a vent or penetration within 300mm of a flue.

Get the holes filled then get your self a free gas safe inspection because your fitter is a !!!!

 

[Ermintrude]

Never swapped logic + for a vogue but think vogue is longer is taller from top to bottom. And gas might be 22mm from memory?

 

[Scott_D]

Let's hope the gas supply isn't live back to the meter

 

[Ermintrude]

No one would disregard GSIUR to that extent! Sure meter is capped and temporary cross bonding in place

 

[GasmanxxxR1]

Zebedy, i think your being a little critical of the engineer, let him finish the job before you rip it to shreds, yes it looks rough but he might be fairly new to the game and its not finished yet

 

[Dotty]

Hopefully there is a gsr and it's not the op chancing his arm with us.

Not easy to tell but I'm watching this one see how it pans out!

 

[Leo21]

Zebedy, i think your being a little critical of the engineer, let him finish the job before you rip it to shreds, yes it looks rough but he might be fairly new to the game and its not finished yet

In other words , zebedy. Wind your neck in!

 

[phil the bucket]

Hopefully there is a gsr and it's not the op chancing his arm with us.

Not easy to tell but I'm watching this one see how it pans out!

Exactly what I was thinking croppie

 

[Leo21]

It is quite rough though. Is it one if AP,s jobs?

 

[Ermintrude]

Ok so how was the installer going to make good the old flue hole behind the boiler after he hung it? Make the external opening so huge he could get access? Or just crumple up template and shove in..... Ideal templates are card so it's much harder than with a Baxi.

 

[Rickster123]

It is quite rough though. Is it one if AP,s jobs?

How very dare you! I'm a clipboard man these days remember!

 

[novicegas]

Why was the reskim not done before hanging the boiler? It'll never be done now and it'll always look poor. Will painting the pipes add more strength to the runs, negating the use of clips, could be one excuse for not using even one! That much burn for what looks like a pressure relief is poor newbie or not.

 

[Ermintrude]

Reskim the customers project management but rest down to mate safe combi cowboy! Some one else did pipe work? Perhaps Ray Charles is back in the game?