- Messages
- 578
Been wondering a while and finally curiosity has got the better of me. Was going to ring Pegler but they have all gone home. Have a few terrier valves to fit. On all of them the olive on the radiator tail is only
say 2, or 3 at the most, mm down the tail stem. Would it not be better if the stem went further down the valve orifice a bit more? The valves have a stop about 10mm down inside them making the 2/3mm
seem, to my mind, a bit of a mistake. Am I missing the obvious?
say 2, or 3 at the most, mm down the tail stem. Would it not be better if the stem went further down the valve orifice a bit more? The valves have a stop about 10mm down inside them making the 2/3mm
seem, to my mind, a bit of a mistake. Am I missing the obvious?