N
Nat
Hi all,
Went to look at a job this evening - change the 2 immersions on a fortic cylinder. I want to pick them up before i go do it but haven't got a clue what size i need.
I was tired and the place smelt funny and i just wanted to get out of there so I never even measured the cylinder but it was about 1400mm high and 500-600mm diameter - sorry I know this is really vague!
I've never even done one of these before is it likely to be a nightmare? What would you estimate time-wise to do a job like this? Anything I need to know or any tips?
Many thanks,
Nat
Went to look at a job this evening - change the 2 immersions on a fortic cylinder. I want to pick them up before i go do it but haven't got a clue what size i need.
I was tired and the place smelt funny and i just wanted to get out of there so I never even measured the cylinder but it was about 1400mm high and 500-600mm diameter - sorry I know this is really vague!
I've never even done one of these before is it likely to be a nightmare? What would you estimate time-wise to do a job like this? Anything I need to know or any tips?
Many thanks,
Nat