- Messages
- 40
A neon screwie and a hammer
Discuss Gas Engineers Toolbox in the Plumbing Jobs | The Job-board area at PlumbersForums.net
I like to keep a bahco 10" wide jaw shifter in my everyday toolbox , it fits 1" nuts a treat without having to go out to van. Have i not convinced you yet ?
Blue coloured shoes are not great down parkhead way, youill end up way one of your boots up your jacksay.
good man , 67 & lisbon i new there was a connection there.considering im a tim i'm not worried about that one lol
which box? the service box, the break down box, the install box, or the i forgot i even had that any more bucket?
mind the paintwork getting it in the house...Going from memory ( i'm only in it 50 times a day) this is what i have in my main box.
Screwdrivers, every size and type i could every need about 15 - 20 of them.
Pipeslices 15, 22 and 28mm (2 x 15 and 2 x 22mm)
Pipecutters, Rigid up to 42mm
Estwing
Feathersplitter
Woodchisels, 1/4" 1/2" 3/4" 1" 1 1/4"
Footprints, 9" and 12"
Knipex Alligators 180mm, 2 x 250mm, 1 x 300mm
Knipex Cobra's 250mm
Knipex smooth jaw grips 250mm.
Bacho adjustables 4" and 8"
4lb club hammer
Cold chisels, 9" 12" and 18"
Multimeter
Test lamp
Socket tester
Knipex pliars, 8" side cut, 4" long nose and wire strippers.
Another old pair of pliars i've had for 20 years!
Circlip pliars
Allen keys, 2 sets
T Bar allen key
Bending springs 8, 10 and 15mm
15 and 22mm guides
Stanley knife and a box of blades.
Half round file and a rasp.
A couple of short rsed drifts.
A load of speed bits in various sizes.
A load of masonary bits 5mm - 25mm
Some metal drills.
A pad saw
A set of metric spanners
A smoke match holder.
2 junior hacksaws, 1 cut back for tight working.
The usual half cwt of screws nuts rings bolts washers and fittings and a few more things i've missed.
There is another box in the van with stuff i don't use much and about another 6 boxes in the garage.
I never carry my own box :lol:
mind the paintwork getting it in the house...View attachment 4223
The only downside is that it does not fit in the toolbox, but is a decent tool when its neededI think one of the best tools for saving time and making money has to be a wet and dry hoover, I went to a job where the customer thought there was a major problem that I fixed within minutes removing an airlock on the hot water . The customer was delighted and so way I, used it yesterday to suck out water in a stopcock pit , cannot recommend enought
Reply to Gas Engineers Toolbox in the Plumbing Jobs | The Job-board area at PlumbersForums.net