Discuss Electric water heaters in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

mfgs

Plumbers Arms member
Plumber
Gas Engineer
Messages
3,468
I need to fit an electric water heater in a flat, it will be used to supply hot water to the kitchen sink and the basin in the bathroom. An electric shower is being fitted, so it only needs to supply two outlets. Any recommendations? I have never fitted one before.
 
as big as you can go 30l if it will fit
 
Do these heaters have a prv?

yes on the 30 they have temp and you need to add a pressure inline also after the pressure reducing valve you g3 reg?
 
Yeah, the position makes the discharge an issue.
 
Do below 15L still have a discharge?

any of them will as depending on where you site it you will need a blow off (save over pressure)
 
Status
Not open for further replies.

Reply to Electric water heaters in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from...
Replies
0
Views
119
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON...
Replies
6
Views
298
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
309
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock