B
Barry98
fitted another today , no problems so happy bunny
Discuss Baxi Neta Tec - anyone fitted one yet? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
I read the instruction and follow what the rep told me, maybe I have been lucky but I think these are a really good boiler.out of fifthteeen fitted twelve have had various problems, inlet test point is really hard to get to, washers pack are slighty oversized so really difficult to fit when fitted to minium height to surface, gas valve problems diverter problems won't waste anymore time on them anymore!
What problem did you have.have fitted one and had problems with it,customer supplyed boiler because of 5 year waranty baxi wont honour that now because i didnt register with works first there was nothing supplyed with the boiler to tel me this . do me and the customer feel like weve had our pants pulled down =yes . these boilers and baxi support are crap,worster all the way for me.
In my opinion most of the problems are the engineers fault for not reading the instructions.couldnt get it out of chimney sweep mode press the 2 buttons and display kept going back to 303 80, after spending about 50 mins on the phone to baxi and doing a re commition they said as it was working they would be round to look a week later, before week was up the customer had to phone them because heating hadnt come on they left him with no paperwork so dont know what was wrong.
Whats with the self commissioning?
Thanks in advance....
Ring me Sunday if you like. Really easy to fit. No it doesn't say about running hot tap but I was told too do it by the rep before I fitted any. I have now fitted about 10 or so now with no problems at all.Thanks for the reply mate.
When are you available to talk. As i am not fitting until Sunday. Just downloaded the installation instructions and doesnt seem to bad. Just doesnt mention about running hot type while it is going through sequence.
Thanks for the reply mate.
When are you available to talk. As i am not fitting until Sunday. Just downloaded the installation instructions and doesnt seem to bad. Just doesnt mention about running hot type while it is going through sequence.
Reply to Baxi Neta Tec - anyone fitted one yet? in the Plumbing Jobs | The Job-board area at PlumbersForums.net