Hi guys,
Just replaced some radiators in a recently purchased student let. The boiler is a 12 year old vitodens 100, 7248589.
I tested the heating and hot water before draining down and it seemed to be working, maybe a little lack lustre on the heating.
After completing the rads, refilling...
Hi all,
I have installed Viessmann vitodense 100 combi boiler and about to connect to my wiring center, I could not find to which connector/port on the boiler should I wire switch live. Has anyone experience with this?
I have viessmann vitodens wb1b 100 boiler and im trying to install a honeywell t5+ wifi thermostat. I currently have a 2 wire thermostat with no c-wire. Can anyone help me with directions and or pictures?
Hi, i’m looking to upgrade my heating system; i currently have an unvented system with a Potterton Boiler, cylinder in the airing cupboard (1st floor).
what i want to do is change the boiler to a Viessmann in a new position - cupboard at the front of the property - see pics.
Also i want the...
I have two Vitodens 200-W system boilers connected via a low loss header. They are about 7 years old and have run perfectly since they were first installed until now. They were installed as part of a whole house re-plumb and have had Fernox MB-1 Heating Protector in the circuit since day one...
We had this problem for a few days last year, but has appeared again. During these warmer temperatures that we are currently experiencing our boiler stops heating the hot water. Upto a couple of days ago when it was cooler it was working fine, and if as last year as soon as it cools off again...
Hi Guys, for called out the other day to attend a no hot water issue, water was going through the rads so ordered up and changed step motor and cartridge. All working well until I'm sitting at a concert and get a message boiler is showing fault 06. I'm no familiar with these boiler can someone...
Quick question. Already know the answer. Boiler keeps coming up F4. Runs for a while but then fails. It's something in the boiler? Just don't want it to be anything I missed outside the boiler before I tell the customer to get their lpg engineer in.
Hi Guys,
New to the forum and absolute rookie so please have a mercy :)
I have a combi Viessmann vitodens 100w which does not give the hot water constantly, we have moved in to the house 6 months ago and when during the summer months it's not a big issue, during the winter it would be nice to...
2 engineers were called prior to me getting the call. The customer having problems with the hot water and it constantly faulting to F2 within 10 seconds of running a hot tap after every reset. 1st engineer changed the Button Stat to the main hex & charged her £120. Still same problem! 2nd...
Anyone fitted one of these boilers and if so what is their opinion of them. Got a Combi to Combi swap and my merchant is selling them for £700.00 with flue. Seems like a bargain but also too good to be true considering I usually pay about £1000.00 for a Worcester
Normally fit the Worcester...
Hi all,
Got a customer with a vitodens 100 boiler that needs topping up at least 2 times a day. I topped it up and over 15 mins noticed it had dropped just under 1/4 bar. All rad valves dry and rads bled. Could it be expansion vessel?
I'm not gas safe but would like to steer customer in right...
Greetings guys
i was hoping you might help an old fella out with what ill seem rather simple issue for you tech savey guys in regards to the programming of my veissmann combi boiler.
we have Installed as mentioned above the veissmann vitodens 222F combi gas boiler with the vitotronic 200...
Ole Fella
Thread
boiler
central
central heating system
combi
combi boiler
help
oil
vitodens
water
Been to a vitodens 100 that is warming up and shutting off quite quick, the pump is spinning and adjusting speed no problem however heat isn't being transferred to rads or cylinder.
This vitodens model is the earlier one without the air vent on off heat exchanger , I'm starting to think it...
Hi Everyone
hoping someone has some bright ideas for me!
just did an install removed an old ideal ff and replaced it with a veissman as above.
first day of install yesterday, all piped ready to go, I tried to refill the system, blockage in the dreaded feed / vent tee, cut that out replaced...
Hi everyone. I have traced out the wiring today and believe that my boiler is permanently outputting a "1" "call" to the Cylinder stat despite not being enabled by the on board programmer. This means the tank stat permanently sees a "live" and (if cold enough) holds the valve open permanently...
Hi chaps. I have the above boiler for sale...brand new and obviously never fitted or registered.
No flue....so just Boiler Only!!
I'm looking for £550 ono
Any questions give me a shout.
Went to a call today. Was actually a service. Customer had only been using hot water feature on boiler for Summer. Circulation not great. Boiler hitting temperature but circulation to rads not great and circulation to cylinder could be better when set up to heat hot water.
Anyway, I had a spare...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.