I have 480k Rayburn manufactured and installed in 2001. It won't run the heating and cooker burners at same time. It will run them one at a time with no problems. Recently i installed new pump and drive, jets etc. I think it maybe a problem with programmer unit.
Any help please>>>>>
Hi. First off, I registered just to ask this question, after Googling and finding the closest match here (I can't post the URL link, but it shows as Vintage Cannon Cooker Restoration). So hope this is the right place.
I'm trying to find out if it is possible to fix a 1966 Cannon A134 D/2...
MichaelC
Thread
cooker
engineer
gas
looking
overheating
plumber
right
anybody got a manual for a New World 32, very old cooker???
its ridged fixed and needs a very good clean but i really need to try and find the manual so if possible it can be refitted after kitchen revamp. Its not burning very well but may be ok with a good clean up.
Hi everyone, just need a little bit of advice. I'm running a new gas line from the meter to the cooker above ground which will be supported against a side wall , as previous pipework is underground. There are two kitchen cabinets between the cooker space and the pipe route I'm planning to take...
FlowGas
Thread
cooker
details
gas
gas pipe
help
pipe
private
related
if on a safety check you find a cooker grill with yellow flames due to poor condition of cooker( id) is disconnecting it from the bayonnet and putting the cooker outside untill the new cooker comes good enough or would you remove bayonnet and cap untill new cooker comes.
Beko : Cooker Safety Notice
anyone with the above cookers need to contact the manufacturer immediately and stop using the cooker,8 people have already been killed the latest 2 in Cornwall this was in the sun paper 8/12/12
I have just been to look at a Baumatic range cooker, the main oven burner lights but once I release the gas dial it goes off instantly, the ignition etc work fines
I have just been to look at a Baumatic range cooker, the main oven burner lights but once I release the gas dial it goes off instantly, the ignition etc work fines
Been called to static home for above cooker that has very low flame only, on oven burner, regardless of high or low on knob. Suspecting thermostat but can anyone confirm this oven doesn't have a ffd.
Also any good contacts on where to get spares.
thanks in advance
PLM
Hello, can anyone tell if it is ok to use a wall plate adapter or maybe a straight coupler to connect 2 cooker hoses together, i need to raise the cooker up higher than the current hose will allow. thanks for any replies
can a free standing cooker be just that, free standing,the customer wants the cooker standing next to a unit 90 degrees off an out side wall,making the cooker central to room,bayonet can be secured to unit,any thoughts
Can a built in cooker (in kitchen unit about 400mm off the floor) be connected by a normal cooker hose?
Can a gas isolator vavle (compression) be fitted below the kitchen plinth?
Hi,
I have a 21 yr old Stanley Superstar 60 SF range cooker that was converted to run off oil 13 years ago. Im going to install a new boiler, but want convert the Stanley back to SF, disconnect the boiler from the CH and DHW and use it 'dry' (just for cooking and room heating). one plumber...
nande2000uk
Thread
boiler
convert
cooker
oil
range
solid
solid fuel
stanley
years
hi all
i am a newly regd gas safe. i havnt done any landlord cert yet.thinking of a scenario: i am in house to do LGSC, there is a cooker with no MI, how do i deal with a situation? i.e gas rating, burner pressure
thanks
An interesting one this. Now we all know that if the gas rings stay on when the cooker lid is closed then its an ID situation. The question I have is.......
If you remove the lid, it's no longer an ID situation as the risk has been removed. So is it acceptable to remove the lid? I've already put...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.