Anyone drive away from a job and then worry about if you’ve forgot to tighten any nuts

[Dylandyl96]

Just me or anyone else drive away from a job and worry if you tightened all the nuts?

 

[Harvest Fields]

All the time. Just gas safe registered but always get home and overthink what I’ve done! Always do a tightness test and then relight appliances just before I leave but still get home and stress.

Hopefully it gets better, any tips?

Never doubt your own abilities.

 

[SimonG]

Nothing worries me as far as work goes.

More important things to concern the old grey cells.

After all works work.

 

[Dylandyl96]

All the time. Just gas safe registered but always get home and overthink what I’ve done! Always do a tightness test and then relight appliances just before I leave but still get home and stress.

Hopefully it gets better, any tips?

I am the same but getting better now gsr for a year, but still over test and worry

 

[KingDoey]

I never use compression on gas for that reason! Always solder you cant really go wrong then!

 

[ShaunCorbs]

I never use compression on gas for that reason! Always solder you cant really go wrong then!

So how do you connect to appliances as there’s compression fittings on them

 

[Dylandyl96]

So how do you connect to appliances as there’s compression fittings on them

I was going to ask the same thing

 

[Michael1960]

Just me or anyone else drive away from a job and worry if you tightened all the nuts?

Every job every day, im 58. Lost count of times ive gone back on pretence of leaving spanners behind. Never found a loose one yet mind, or a flue inspection cap.

 

[Michael1960]

All the time. Just gas safe registered but always get home and overthink what I’ve done! Always do a tightness test and then relight appliances just before I leave but still get home and stress.



Hopefully it gets better, any tips?

 

[Dylandyl96]

Every job every day, im 58. Lost count of times ive gone back on pretence of leaving spanners behind. Never found a loose one yet mind, or a flue inspection cap.

Like it good excuse to go back and check

 

[Michael1960]

Stella artois

 

[MARTIN LISTER]

Put the flue test plug in your pocket. If you forget to refit there is a reminder that you are bound to discover.

 

[Alan Rivis]

Just me or anyone else drive away from a job and worry if you tightened all the nuts?

Yep many times on occasions even gone back to double check

 

[billski]

I've filled the heating system up a few times and missed a radiator. When you open a bedroom door and see a jet of water spraying out of the bleed nipple! Quickly get the wet vac out and hope it's not leaked through the ceiling.
The worst one is when a customer wants to chat when I'm fixing or servicing a boiler. Then you go in to auto pilot, and even though you've tightened and checked everything you'll doubt your self when you drive off in the van. Best to ask the customer to let you get on and try not to look at your phone. That's when my mind wanders and I forget if I've tightened everything or not.

 

[KingDoey]

So how do you connect to appliances as there’s compression fittings on them

Obviously you cant avoid that.

I mean more like compression backplate fittings or where you see compression used on the pipework...

I should have said I always solder where possible

 

[Wirdy]

All the time, yes.
Tape test plugs to the front of the cover. Last job is normally to refit cover, so obvious if you've forgot to refit them. And never keep any spare plugs in with your analyser! You'll go crazy.