You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
vertical
A vertical jump or vertical leap is the act of jumping upwards into the air. It can be an exercise for building both endurance and strength, and is also a standard test for measuring athletic performance. It may also be referred to as a Sargent jump, named for Dudley Allen Sargent.
Does any one know how reputable/reliable are Joule and Telford when it comes to their unvented vertical hot water cylinders?
We require a 250l vertical cylinder for our basement and our plumber is used to installing Telford Tempest cylinders but read online that Joule may be a better alternative?
I have been looking into purchasing an unvented hot water cylinder system for when we have our loft conversion (we will have a 3rd bathroom), which is starting next week.
Due to storage constraints for the location of the cylinder, the plumbers that have viewed the property have advised either...
"Hello,
I have had a bit of a nightmare on a WB boiler installation.
Basically, it failed on Gas Safe inspection on 3 points.
Installer came out to rectify months after and rectified the boiler regarding access points and flu. However, when we saw the flue, we were shocked. We had no idea it...
Hello,
I have had a bit of a nightmare on a WB boiler installation.
Basically, it failed on Gas Safe inspection on 3 points.
Installer came out to rectify months after and rectified the boiler regarding access points and flu. However, when we saw the flue, we were shocked. We had no idea it...
Morning guys. I have not done many vertical flue installs and am wondering what's the best way to run this flue to get the correct distance from the chimney pots. So it looks like I need to be 1200mm away from them. Is this even with the flue's not in use? Or is there a cap I can put on these If...
Hi all,
My customer wants to install a vertical radiator in his living room (to replace a conventional double panel/single fin rad). His reasons are aesthetic.
We've done a heat loss calculation through the website bestheating.com, through which he intends to buy the rad. The loss is 1.28...
I'm having trouble getting my Column Radiators in Kitchen (2) & Lounge (2) getting hot at the bottom. The system is less than 2 years old and powered by a new Worcester 42CDI.
All the other Rads seem to get hot. The boiler is turned up to max and all Rads have been Bled and there's no air in...
vanurdi010310
Thread
bottom
check
cold
column
radiator
radiators
return
system
vertical
Morning all
cant find it in the book and Glowworm technical are impossible to get hold of these days.
Vertical flue clearance from soil pipe vent. I am assuming is 600mm? Anyone confirm this?
cheers
I need a vertical adaptor for a Hermann Icon 23T boiler (installed 2001), does anyone know if I can still get hold of this?
Any help appreciated!
Many thanks, Tony.
Hi
I have to fit a 1800x400 double radiator and have a query as to how to fit the bottom cup brackets, I have attaced link and the diagram (c) shows the bottom brackets pointing down, is this correct for such a large radiator, I am unable to find any further information on the net and wondered...
Hi
has anyone fitted a vailant penetration collar. I went to a boiler today and the flue comes through a flat roof its a vaillant eco tec pro 24. Looking on line it appears that there should be a seal that goes around the bottom of the flue. link below. Is the flue fitted right there is a gap...
I've never fitted a vertical rad yet but will be doing so on Saturday. .
I've done a little research and know it's important to pipe up the flow on the correct side of the rad so it flows through the entire rad and not just the outside.
My question is this:
Say the flow is on the left, can...
Hi
The job is I need to send a flue for a worcester greenstar 28i junior vertical up past the roof line as there is an extention being built. There will be 2 90degree bends including the bend on top of the boiler and 2 45 degree bends. And the height is about 4 meters. I've worked out that I...
Hi everyone,
I'm currently installing a new bathroom and using Saniflo to pump all the waste to the soil stack. However, the waste pipe has a vertical lift of about 40cm at the very end where it joins on to the soil stack. I've read everywhere that the vertical lift should always precede the...
slantsaman
Thread
after
horizontal
lift
pipe
saniflo
vertical
waste
waste pipe
Hi guys
Really need some help...
We have a Warmflow 70/90 Oil Fired Combi Boiler. We're looking at putting a porch/conservatory on to the property, right where the flue exits the external wall.
I have a couple of solutions for the flue but I REALLLY need to know what the maximum horizontal...
hi everyone, back to a finish a job tomorrow with my boss who is gas safe registered.
we have installed a new glow worm c30 combi boiler in a new build garage which has a slight pitched roof.
we have the flue from boiler going straight up in two sections. the first section is 1meter long and...
I just bought several vertical column hudson reed rads to install in new hot water heating system. I notice that when I screw the vales to the two lower rad ports that I can look straight thru to the other port. I expected there to be a baffle of sorts directing hot water up thru the crumbs and...
Naphelge
Thread
column
feeds
installed
ports
return
valves
vertical
water
I just bought several vertical column hudson reed rads to install in new hot water heating system. I notice that when I screw the vales to the two lower rad ports that I can look straight thru to the other port. I expected there to be a baffle of sorts directing hot water up thru the crumbs and...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.