You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
shower
A shower is a place in which a person bathes under a spray of typically warm or hot water. Indoors, there is a drain in the floor. Most showers have temperature, spray pressure and adjustable showerhead nozzle. The simplest showers have a swivelling nozzle aiming down on the user, while more complex showers have a showerhead connected to a hose that has a mounting bracket. This allows the showerer to hold the showerhead by hand to spray the water at different parts of their body. A shower can be installed in a small shower stall or bathtub with a plastic shower curtain or door. Showering is common in Western culture due to the efficiency of using it compared with a bathtub. Its use in hygiene is, therefore, common practice.
Hi - recognise this a bit of an odd one. We have an old failed mixer valve which we need to replace. This valve actually predates a temperature controlled boiler, so the mixing functionality is irrelevant, since the cold water pipe is isolated/off.
I'd ideally like to replace the shower valve...
Hi I've purchased a GROHE | Euphoria 260 Exposed Shower ( looks nice ) however Im missing some initial connecting adapters the installation instructions say it comes with " easy install adapters " and threaded tape ....I have neither of these ,all I have is the " S " unions ... so I did a bit of...
Hi, I have a shower tower fitted and my flexi pipes (500mm) are about 7cm short of where they need to be to fit onto the mixing valve in the back of the shower. I cannot move the shower up and the next longest flexi pipe I can find is 900mm, which is about 830mm longer than I need.. Would a 15mm...
Void under shower former
My recently installed solid resin shower tray / wet room former has around 4mm flex across a dinner plate sized area in the middle. It's on a concrete base that was unevenly screeded over. The gap will likely be under 10mm. It has not yet been tanked or tiled but would...
I am redoing my bathroom and not sure what the best way of doing my shower is which is in my bath, I want a rain shower and so I was thinking of using a thermostatic shower valve as I have removed the plasterboard to re tile (new build) and thought this is a good opportunity to do it, my...
Hi all, I'm trying to remove this shower mixer however, I cannot see any bolts like all the other ones I see online.
Please can someone advise. I've taken a picture of it: Screenshot - https://prnt.sc/YS6WnqriFxHP
Hi, we were getting uneven shower pressure and fluctuating temperature from the shower. A plumber advised that we replace the shower which we did. The temperature is now good but the water pressure is still uneven. We get mains pressure for about 2 minutes and then the pressure drops right away...
Hi, My tenants were experiencing uneven pressure and temperature from the shower. Plumber advised that we replace the shower which we did. Now we have good temperature but the pressure is still uneven. The shower starts full mains pressure then after about 2 minutes it drops right away and there...
I want to swap my electric shower to a power shower. I have a 200 litre pressurised hot water tank in the loft (not a combi boiler) the hot side has a pump and decent flow, but the cold side/hot side has not got an equal pressure as the cold is just mains fed and would say the flow is below...
Hi, am getting our bathroom updated and local company suggested ditching our traditional attic CW tank/vented cylinder and pump for the shower and install an unvented pressurised HW cylinder instead. We have been told that this will not lead to a drop in effective pressure from the shower. Is...
Hello all, hope someone can help I'm after a joint which was missing from a purchase i bought years ago, just getting round to fitting it now, any idea where I can get one?
Pipe inlet is 18mm diameter and thread is 3/4" BSP
Hi all
I've finished running the copper for my concealed shower valve and tested both inlets and the outlet with cold mains (full pressure).
I just wanted to ask is it considered necessary to test the hot inlet with hot water, or will the cold suffice?
Many thanks
P
Attached is a ground floor picture of the soil pipe in our home. There was originally a toilet which has now been permanently capped off and you can also see a sink waste pipe attached.
My plan is to drill out one of the 50mm sockets directly opposite the current sink waste for a new 40mm...
Hello
Yesterday my aqualisa shower sharted making a whirring sound and trickles of water came out of itwhen the boiler came on to heat up the water . When i went to try the shower it was dead. After turning it off and trying for most of the day it finally started. BUT only hot water came out...
My Duraspeed pump has started to make a strange noise when water is drawn but I can't see where to add a video. It was already installed when we moved in last year and may have given up the ghost after battling with an air lock in the system? Any help would be gratefully received.
Hi has anyone ever renew a thermostatic shower cartridge on a Firedearth shower in photo I’m trying to find replacement Firedearth will tell me the manufacturer of mixer
Hi, in order to replace the solenoid on my shower I need to take it off the wall (bad shower design).
I've got all the electrics disconnected, it's detached from the wall itself and I've unscrewed where the water pipe from the wall connects to the shower inlet (I'm sorry I don't know the right...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.