motorised valve

The Motorised Submersible Canoe (MSC), nicknamed Sleeping Beauty, was built by the British Special Operations Executive (SOE) during World War II as an underwater vehicle for a single frogman to perform clandestine reconnaissance or attacks against enemy vessels.

View More On Wikipedia.org
  1. M

    rads won`t get hot ?

    hello all, i`ve been asked to look at a central heating system in a small office block (2 separate offices, one downstairs,one up ) the boiler is located in the downstairs office,the radiators were turned off by the thermostat in the warm weather a week ago or so,but when the radiators were...
  2. R

    cylinder stat wiring

    Im replacing my cylinder stat but am unsure of connections . Existing stat has 2 connections ...one goes to programmer & other goes to hot water motorised valve . New stat has 3 terminals ....I assume common connects to programmer as the feed ,but does the motorised valve lead go to the call for...
  3. M

    Hot Water problem

    When the hot water is switched on (emersion system) the central heating comes on at the same time. I have turned the hall thermostat down to zero, thinking this would help, but it doesn't. Any suggestions?
  4. P

    Reverse Termosyphone

    Hi guys. I'm new here and looking for some advice. I'm about to plumb a heating system which has both an oil boiler and solid fuel stove. The stove is on the ground floor with the dual coil cylinder on the first floor about 15ft away. I intend using both sets of tappings on the stove, one...
  5. C

    Vaillant EcoTec plus 438 problem

    I wonder if anyone can help - three plumbers I've had in can't! I have an EcoTec 438 which was working perfectly. I closed off the valves on one red to remove it and redecorate a room. The heating continued to work perfectly. I replaced the rad, opened the valves and re-filled it, closing off...
  6. D

    Simple ch problem?

    Hi! First post - so please be tolerant if I'm raising an issue that's been covered before. My daughter has moved into an old mid-terraced property with a very basic wall-mounted boiler; it has a timer but no switching to permit heating only, or hot water only etc. The radiators are not...
  7. S

    Programmer wiring help

    Could someone please help me to wire the programmer in correctly. We had a problem with the motorised valve and initially I thought it was the time clock so I bought a programmer. when it came to fitting it I noticed the wiring was all over the place and didnt match up to the diagram in the...
  8. H

    Hot water only when room thermostat is on!!

    Hi Everyone Just joined. hope someone can help. Replaced honeywell room thermostat with same make and model new one. Wired exactly as old one, but now the water only heats when the thermostat is on. Hollybox
  9. W

    siemans motorised valve

    Hi . Newbie on here. Ive taken the head of a Siemans 2 port valve to change the motor and there was a spring floating about inside un-attatched. Op says nobody was in it before me??. Cant see where it fits back on. Anybody have a drawing.?
  10. P

    new motorised valve, look warm water & rads

    I have replaced the mid pos 3way valve on an open vented system (hot water would not heat without heating rads)& this partialy cured the problem but now water & rads only warm. When i replaced the valve i tried to do it without draining,just closing all wheel head valves to isolate, but one must...
  11. R

    Back boiler problem

    The boiler in queston is a potterton housewarmer legend. The problem is when the hotwater is selected on the programmer all the upstairs radiators come on as well. My 1st thought was it is a faulty motorised valve,however after searching everywhere i cant locate a motorised valve. The pump is...
  12. T

    3 way motorised valve

    I have recently drained the hot water and heating system to replace a radiator. Having flushed the system both HW and CH the only way I get get hot water is to run the central heating. I suspect the valve maybe clogged with the usual black gunge or could there be another explanation?
  13. R

    Re: Boiler Timer and Room Thermostat work independently

    Hi there, When my Boiler Timer is ON, then the Boiler runs irrespective of what the Thermostat setting is (even if the setting is lower than the room temp). However, when it is OFF, the Thermostat takes over and works (turns Boiler ON only if the setting is higher than the room temp)...
  14. eagleeye

    underfloor heating

    Hi guys I have just installed some underfloor heating in a new conservatory that i have just built for a customer. The father of the lady has also just fitted a new Baxi Solo boiler and has told me that the boiler only has a switched live separate pump live. The trouble with this is that if i...
  15. K

    oil boiler problem

    hi all just joined this web site hope someone can help my worcester danes moor oil boiler 20/25 the red power light does not go off when programmer for hot water ends but fires up intermiterly. Tried changing the motorised valve but still the same problem, so at the moment having to switch off...
  16. G

    lifestyle LP722 Fault

    Hello everyone, im new to this. I think i have got a fault on a lifesyle LP722 controller heating not coming on unless the hot water is on. When the heating is selected the 2 port moves across and activates micro switch. 2 port is a newish item. The pump doesnt run i think the heating side is...
  17. S

    honeywell zone valves

    Hello I have checked for items on this forum for problems with honeywell valves but didnt find any that related to a problem I have. I am not a plumber I am a control systems qualified technician. The problem I have is both with honeywell whos support is very poor. In not returning phone calls...
  18. L

    SwitchMaster Bluebox

    Hi all... I have a SwitchMaster BlueBox attached to my central heating. All of a sudden it's started ticking and the dial moves clockwise from Hot water to Central Heating to central heating and hot water.. Then when the heating kicks in the ticking and turning of the dial stops.. Should I...
  19. M

    Potterton suprima 40 blowing 3 amp fuse & rcd.

    My Potterton Suprima 40 is blowing the switch 3amp fuse and tripping the rcd ,it is doing so although the programmer HW & CH are in the off position.I removed the programmer from the backplate & replaced fuse and the red boiler light came on but when iput the programmer back on it blew the fuses...
  20. L

    Haphazard heating

    Hi all, first post so I hope I don't appear too stupid. Heating problem is that the flow and return pipes have heat in them and the rads turn on, but don't stay on for the full timed period. Pressing the advance or turning up the thermostat gets nothing. Hot water works fine. Thermostat clicks...
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock