Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

failed

Failure is the state or condition of not meeting a desirable or intended objective, and may be viewed as the opposite of success. The criteria for failure depends on context, and may be relative to a particular observer or belief system. One person might consider a failure what another person considers a success, particularly in cases of direct competition or a zero-sum game. Similarly, the degree of success or failure in a situation may be differently viewed by distinct observers or participants, such that a situation that one considers to be a failure, another might consider to be a success, a qualified success or a neutral situation.
It may also be difficult or impossible to ascertain whether a situation meets criteria for failure or success due to ambiguous or ill-defined definition of those criteria. Finding useful and effective criteria, or heuristics, to judge the success or failure of a situation may itself be a significant task.

View More On Wikipedia.org
  1. S

    Grundfos Pump - has it failed?

    My Boulter Buderus Camray boiler has shutdown and I think it may be a failed pump. It has a Grundfos UPS 25-60 pump fitted and I removed the large screw to check if the impeller was rotating. From past experience I would expect a steady, but not powerful, stream of water to run from the...
  2. P

    Boiler failed

    Hi all, anyone know what the problem could be with a Glow-worm Betacom 30C, it fires as normal & runs for about 10sec it then goes to flame failure lockout. Boiler only 4 months old so I have booked a engineer visit under warranty, however, they can't come out until Tuesday & could do with...
  3. B

    my performas broken it should not happen to a gasman

    for the first time in nearly 6 years its dead wife rings and says its cold and theres a red light on she is told not to touch anything as she normally breaks it even worst,so gets home quickly discovered its a gas issue as gas hob not working (no dinner either) meter has failed/jammed shut its a...
  4. D

    CH pump failed?

    Hi, a new member of the forum here! I have a Worcester Danesmoor 15/19 oil boiler, and have just tried flushing the CH system to remove sludge. Now it won't fire up. The burner fires OK, then cut out after about a minute. The pump is too hot to touch, but pipes (2 zone valves for CH and/or...
  5. R

    Rads too hot to touch

    Worcester Heatslave 20/25 oil fired boiler 4 years old, diverter valve renewed 3 months ago. I don't seem to have any control over my radiator temps they get seriously hot too hot to touch, not sure if boiler c/h stat is working how can I check, I have turned it fully down and it has no impact...
  6. E

    Help - Blanco 5300 mixer tap - spout failed

    Just had a fountain in the kitchen! We've taken off the spout, can someone tell me what the piece at the bottom of the spout is called. I assume this is the piece that has failed. Do you think we can get a spare or will we need to contact Blanco?
  7. C

    Unvented cylinder scrap value?

    Taking out a massive unvented cylinder next week to replace with an ideal logic :D not my choice.. Has any of you took an unvented to the scrapyard before? Are they worth much
  8. L

    Y plan on unbalanced Megaflow? And a prematurely failed boiler pump?

    Hi, 2 years ago I had a Vaillant ecotec plus 637 boiler fitted and the hot water tank replaced with a 250ltr Megaflow tank. Your views please... 1. Loud noise from boiler prompted me to have it inspected, the pump is done for and I've been told it's all the guff floating around in the CH...
  9. R

    Bath / Shower Taps - Failed switching valve

    Hi all - I am new to this but I hope you can help me a little. We have an old cast iron bath with the mixer tap with a valve to divert the water to the shower head. A traditional style one - two taps connecting in the centre to the shower diverter valve & then to one central spout. This...
  10. R

    Bath / Shower Taps - Failed switching valve

    Hi all - I am new to this but I hope you can help me a little. We have an old cast iron bath with the mixer tap with a valve to divert the water to the shower head. A traditional style one - two taps connecting in the centre to the shower diverter valve & then to one central spout. This...
  11. D

    whole year failed level 3 exam!?! (tech cert)

    WTF just found out that last years group all failed the exam, so my college has a 0% pass rate! From what i hear a lot of the questions in the exam were not in the revision books followed by the course. Surely all the questions would be in the Viper or Corgi?. I just dont understand how no one...
  12. G

    lead loc failed

    Fitted a bathroom suite back in april for large diy store, had to fit 2 lead locs to pipework, after fitting tested under pressure for leaks no problems. the job was left with plasterers and tilers with me going back to final fix. no problems when completed. just recieved bill for refit and...
  13. J

    Central Heating System Failed!

    Hi all, First post so bear with me! Earlier today, my central heating/hot water system failed. The system comprises an Ideal Elan 2 boiler, a Honeywell thermostat, two header tanks in the loft and a cylinder in the airing cupboard. For about a month now, the CH has only been working with...
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock