Discuss HALL of SHAME PHOTo`s in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
DSCF0444.jpgDo you think it was going to be a Low Loss Header & then someone changed there minds???. 3rd connection down on the lefthand side of boiler is the primaries to the cylinders. Wheres the zone valve (only one) ? ,behind the 1st cylinder but where the pump ?? Yes that it on the return going back into the boiler !!!!!! nice one.
 
Last edited:
View attachment 11921Do you think it was going to be a Low Loss Header & then someone changed there minds???. 3rd connection down on the lefthand side of boiler is the primaries to the cylinders. Wheres the zone valve (only one) ? ,behind the 1st cylinder but where the pump ?? Yes that it on the return going back into the boiler !!!!!! nice one.

Someone spent a lot of money on that just a pity there plumber just didn't quite know what he was doing
 
I'm shocked and appalled at what Mike Jackson has had to rectify in his last few posts here. I'm beginning to think Gas Safe should be doing more and come down mega hard on these chancers, I mean what's the worst that's gong to happen to these fools? Slap on the wrist and a few future jobs scrutinised then given the green light to carry on as they were? Not kidding when I say I'm shocked and appalled at this.
 
View attachment 11921Do you think it was going to be a Low Loss Header & then someone changed there minds???. 3rd connection down on the lefthand side of boiler is the primaries to the cylinders. Wheres the zone valve (only one) ? ,behind the 1st cylinder but where the pump ?? Yes that it on the return going back into the boiler !!!!!! nice one.
Chris ,
what are the two pumps feeding to the left ? What is under the boiler rhs a secondery hot water pump ? What's the pump doing on the return to the boiler for and is there no expansion vessels fitted ?? I know is not your work just interest to find out the job specification .
also is both cylinders of one primary flow with one motorised valve ?
 
Yes stan the pump under boiler on right is a grundfos comfort pump for secondary return with built in timer
It's a good pump
 
Chris ,
what are the two pumps feeding to the left ? What is under the boiler rhs a secondery hot water pump ? What's the pump doing on the return to the boiler for and is there no expansion vessels fitted ?? I know is not your work just interest to find out the job specification .
also is both cylinders of one primary flow with one motorised valve ?
Hi Stan
One does heating on the first & 2nd, the other the U/F on the whole Ground floor. (as Gray below) as for the other pump it sucks the water around the cylinders & a 22mm towel rail circuit as well as aiding & abetting the other two heating pumps it would seem (mind you all are 15/50's on speed 3) expansion vessel & loop are on the floor to the left out of shot. Job specification ??? no there wasn't one (I asked) which went along with the insulation on all the pipework not just in the plant room throughout the whole house.
 
Expansion vessel should be sited on pipe work with no valves on or between it and the heat source?
 
Expansion vessel should be sited on pipe work with no valves on or between it and the heat source?
We know that vern but TBH I think thats the least of this guy's problems, my reports going to be a long one !!!
 
Last edited:
Status
Not open for further replies.

Reply to HALL of SHAME PHOTo`s in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock