Discuss Old system playing up in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
turn the power off

move the yellow wire to no 1 terminal (eg red and yellow together)

heating should start
 
Stat broken.

Power off, put yellow onto red terminal, with red still on there, Power back. You will have linked out the stat till you get a new one.
 
Yes Honeywell 6360b should sort you out
 
red in 1
yellow in 3
blue in 2
earth in eath
 
That one Shaun mentioned is good. Get one of them!

As I know that the rads used to heat a bit when the hot water was on (only hot water) I may still swap out the full valve and fully drain the system,, any inhibitors that you would recommend for my system & netaheat boilers?

Also, the water going into the expansion tank, if this continues after the thermostat change is there anything that this screams out as, as a fault?
 
Status
Not open for further replies.

Reply to Old system playing up in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock