New Vaillant flues

[wattsie1987]

Whats everyone else's opinion on the new Vaillant flue? I think it's total pap the terminal looks like a dog muzzle and not being able to fit the external collar after fitting the flue is a right pain. I've been told that the plume kit bow needs 45ing back to Wall because the terminal sticks out so far.Other than possibly trying to prevent water ingress can't see why they've done it. There no seam on the outer flue which is a plus but other than that it's terrible.

 

[wattsie1987]

Not sure but a good chance glowworm have gone the same way?

 

[Scott_D]

So you can't make good the flue hole?

 

[wattsie1987]

So you can't make good the flue hole?

Not really unless you fit the flue long so the collar can be pulled forward made good then be pushed back.( I hate flues that aren't perfect length) Not read MI's yet Haha but just seems stupid!

 

[kozak1968]

You unclip the original terminal and clip the plume kit terminal in. The original flue needs to be the correct distance off the wall within reason. If it sticks too far out you will need 45s to bring it closer to the wall. Ive never had a problem with them.

 

[kozak1968]

You unclip the original terminal and clip the plume kit terminal in. The original flue needs to be the correct distance off the wall within reason. If it sticks too far out you will need 45s to bring it closer to the wall. Ive never had a problem with them.

 

[wattsie1987]

You unclip the original terminal and clip the plume kit terminal in. The original flue needs to be the correct distance off the wall within reason. If it sticks too far out you will need 45s to bring it closer to the wall. Ive never had a problem with them.

How do you go about making good the outside mate?

 

[kozak1968]

The plume kit can be put on an existing flue. Just take the rubber collar off and pop the dimple bits to release the terminal. There should be no making good needed.

 

[kozak1968]

The only awkward thing is getting the old terminal off the inner duct. A screw driver usually works to prize it off.

 

[ShaunCorbs]

you got a pic of the flue wats?

 

[wattsie1987]

The plume kit can be put on an existing flue. Just take the rubber collar off and pop the dimple bits to release the terminal. There should be no making good needed.

Your talking about the original flue mate the new one has a plastic collar and a screwed terminal it's a totally different design. The collar can't be removed from the flue over the terminal hence the making good issue. The plume kits totally changed too even the clips have offset fixings.

 

[wattsie1987]

you got a pic of the flue wats?

No mate didn't think I'll get one next week

 

[smtplumbing]

I was told its q erp flue load of poo lol.

 

[hammers4spanner]

Is that the flue i have seen lately on new builds with the snorkel thing on the end?

 

[kozak1968]

Got a part number anybody?