Jet Swet saves the day

[Dannypipe]

I've got everything I need to make my own on the van already. Great idea Mick, I'm going to do my own. I'll use 10mm tube as a sleeve though as you say steel tube would be better.

 

[mickie]

Good stuff, if you do use a coach bolt id file off the little square bits and get some steel washers that fit exactly over the M6 bolt and are 20mm wide so theirs no gaps as it fits inside the 22mm pipe as i found with some washers if their is a gap the rubber pushes past the steel washer inside the pipe, it would probably split it after a while..

 

[Dannypipe]

I was planning on using 6mm threaded bar (stud - I call it). With two nuts and a steel washer on one end, then the rubber washers, followed by a steel washer, the 10mm tube and another nut. Job's a goodun!

 

[antdad]

How about making a larger version of this?

 

[gassafe]

I use these, very handy

6 Nylon Drain Plugs | Specialist Plumbing | NoLinkingToThis