Currently reading:
Introduction Thread

Discuss Introduction Thread in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

J Thane

Hi, i have been a gas engineer for over 5 years now since leaving the Royal Navy. This forum is a good way for confirming defect diagnosis. A good example is the Heat Line F5 fault.
 
Hello J, welcome to the forum.
build up your post count, there is a section for registered installers which you could get access to.
 
Welcome J. You need a minimum of 10 posts then send a private message to either REDSAW or Gas man with your gsr details.
 
Status
Not open for further replies.

Reply to Introduction Thread in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Back
Top