Search the forum,

casing

Casing is a large diameter pipe that is assembled and inserted into a recently drilled section of a borehole. Similar to the bones of a spine protecting the spinal cord, casing is set inside the drilled borehole to protect and support the wellstream. The lower portion (and sometimes the entirety) is typically held in place with cement. Deeper strings usually are not cemented all the way to the surface, so the weight of the pipe must be partially supported by a casing hanger in the wellhead.

View More On Wikipedia.org
  1. B

    Ideal logic products of combustion in casing

    Has anyone else come across this situation? I keep detecting products of combustion inside the casing of Ideal Logic boilers. I've replaced every seal I can find, namely flue seals, turret seals, sump connection seals, burner seal, electrode seal, flame detection seal, etc, and yet still I pick...
  2. D

    Installer Plug casing for UPS3

    Hiyas. Not holding out much hope as it’s looking more likely that I might have to buy the full installer plug but does anyone know if you can buy the below casing separately instead of the full installer plug and what part number it is if you can? The gentleman from the housing association who...
  3. H

    Boilermate A class OV leak from casing seal advice

    Re - Boiler Mate A class OV We have a leak coming up from the unit casing seal around the open vent . The top of the unit is pop riveted . I intend drilling out the rivets and taking off the top of the casing . Is there an exploded view of what I will find and any joints under the casing...
  4. T

    Condensation inside Heat only boiler casing - a couple of questions.

    Hi all, I've got a British Gas 330+ Heat only boiler and it displayed an F25 error (lack of water iirc) on Sunday. I read the manual and bled the radiators (1 rad had quite a bit of air) and topped the system up a little and sure enough I could then hear water flowing back into the boiler. I...
  5. B

    Warm Danfloss casing

    Can anyone tell me if the casing on a Danfloss three port valve should always be warm even when the boiler isn't turned on as I only noticed recently and it's only a year old and working fine
  6. D

    Gazco Riva2 670 - Battery Casing Receiver Issues

    Hi, I have a Riva2 670 gas fire that is now about to have it's 3rd new battery control box receiver in 3 years. It seems to be becoming an annual event. The bleeps given indicate a wiring issue, however on reviewing the wires all is fine. Replacement of the receiver fixes it. I'm wondering if...
  7. O

    Shower installation - Hole in tile and small gap in casing

    Hi all, I've just had an electric shower installed but I'm unsure if I have a problem. The plumber mentioned that the pipe was on the wrong side and couldn't easily be moved so he has installed it the best he can but there is an exposed hole in the tile and also the casing hasn't quite closed...
  8. J

    worcester bosch 28cdi (old boier) cold water feed inlet filter

    Hi I would appreciate some advice as my boiler has a small leak from cold water feed at the back of boiler. The bit where the copper pipe feeds into the cold water inlet filter. Is it possible to fix this easily myself, or how much would it cost for a plumber to fix. Thanks jim
  9. L

    Ideal Concord Casing Seal WRS 240A - Desp Needed

    HELP! Am selling my house and my very old yet reliable boiler failed its safety inspection on its casing seal. Apart from thats its great. Everywhere I ask this item is obsolete. and if I can't find the part I will have to give the buyers £3k for a new boiler which i so don't want to do... Any...
  10. M

    helpful advise on boiler casing

    Had annual service today and fitter snaged boiler and dissconected it ,outside of the casing has a 10mm hole in the top caused by corrosion and it is leaking fumes which i understand . What i need to know is do i need a new boiler are can I get the hole repaired by bolting a plate over the hole...
  11. Hobo128

    Boiler only fires with casing off!

    Went to a job the other day, customers boiler had stopped working. i took the casing (combustion casing off) and it lit up. I put the case back on and it stayed lit. When I turned it off and back on it didn't light Dhw or Central heating. I checked the air pressure that was fine and checked the...
  12. V

    Heating not working

    I've got an old floor standing boiler, switched the heating on, via the timer but nothing is happening, I have noticed in the cupboard there is two pumps, one is working and I can hear it and feel it working, the other one is extremely hot and there is a small leak on the pump and a build up of...
  13. Z

    Rusty worcester boiler

    Hi, I'm new to this forum and was looking for some advice. we have a worcester bosh boiler and have just had a minor repair done,but have been told we will need a new boiler? The boiler is about 5 years old and has some rust it the bottom of the casing and I was told it's been corroded by...
  14. B

    Glowworm ultimate - front casing feels too hot

    Hi guys, any reason why the front casing on a glowworm ultimate Would get too hot? i serviced this boiler a found everything to be ok but one it was back together and heating up, the front case feels a little too hot for my liking. It's not 'ouch yer f*ucker' but it defo hot by the way...
  15. J

    ideal elan casing seal?

    anyone any idea where i could get a suitable casing seal for my ideal elan balanced flue boiler? The old one is just an asbestos/rope type of thing but its getting a bit worn now & needs replacement. I know the boiler is 27 years old but I dont want to replace it with a modern unreliable piece...
  16. RGII79

    Ideal logic system18 problem with intermittant leak inside boiler casing only install

    Any one any experience with this
  17. L

    Mira Advance Thermostatic ATL

    Alright lads. I've got a Mira Advance Thermostatic ATL which has three pressure settings. The push button on the high pressure setting is not working, does this mean it needs a whole new casing? Cheers :waving:
  18. T

    37 CDi Intermittant problem

    I'm posting this for another member who cant get it to post a new thread Hi For some reason it will not allow me to post a new thread something to do with 'permissions'. So I am desperate for help for this problem: I have a 4 year old Worcester Greenstar 37CDi combi boiler. Two years ago it...
  19. P

    Some advice

    A belated merry Christmas. I wondered if any of you gas safe guys could provide some advice. I operate in area that is largely off the gas grid, so I do not do gas work, only oil. However there have been a couple of occasions when I have needed to access the pump to bleed it after installing...
  20. F

    ferroli f 30b

    heating working fine hot water runs hot and cold it runs for about 3 mins or so then shuts down tap runs cold boiler fires back up after about 30 secs then will run for about 3 to 5 mins then so on but can somtimes run a bath ok
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock