Discuss New thermostat for my boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
169
I'm after replacing my thermostat with a wireless programmable one to work with betacom 30c. Which thermostat do you recommend ?
 
Do you know much about electrics? Have a multimeter? An RF one does need wired in to the boiler. Its the thermostat that send a signal to the receiver which in turn sends a signal to the boiler to fire through a cable.

My recommendation is to get an engineer out to wire it up. Saves you any grief or possible electric shock. lol.

Should cost you an hours labour plus materials.

You know then the work will be covered by their own warranty on the installation (Mine is 12 Months) of the stat. You will get the right one and it has been installed correctly.

Surely that alone, never mind any potential headaches, is worth an hours labour to a competent local engineer. They would appreciate the support as it is tough out there and if you like them then they could be invaluable to you in the winter when your boiler goes down.
 
Last edited:
I'm an electrician mate although not very familiar with boilers I'm sure I'll be able to work it out
 
Honeywell CM927, Drayton MiStat are both decent. Delta Dore also look fairly good.

Avoid Salus, Horstmann, Siemans.
 
Cheers mate I'll have a look at them later. Which ones the best in your experience? How far away from the boiler does the reciever have to be?
 
Screwfix do a cheap one I've installed a fair bit with no come backs
 
Delta dore I'm going to say I haven't used one yet but my next one going in will be!
 
Been hearing tales of woe re: honeywell although I've had no callbacks myself
 
Status
Not open for further replies.

Reply to New thermostat for my boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top