Jet Swet saves the day

[keltoyboy]

View attachment 16219

Safe as houses. Really got me out of trouble today.

looks cool..... so what price are they??

 

[Killy Bing]

I will say this, they are fine for when another valve is letting by or you want to extend a tail from a floor but there is water in it, allowing you to hoover it out

.these are not to replace live valves......... Ever!

tried and tested twice!
on 15 and 22.

far less messy to just snatch

 

[Gas]

They are a complete load of rubbish

 

[Bunker]

They are a complete load of rubbish

In what way? How did one fail you?

 

[Mickyplumb]

They are a complete load of rubbish

Have you ever used one Gas ?

 

[Ermintrude]

I use them to snatch gas

 

[mickie]

I think they're a good idea but i don't think they're worth £60 quid, mine cost £2.50 and holds back mains pressure easy..

 

[Dannypipe]

Love that Mickey. Can you show us a break down on how you made it? I want to make myself one!

 

[mickie]

I used some tap washers, 7 in total, mine were slightly too big and had no holes in the middle, ideally you'd want to find some with atleast holes in about 5mm to take a m6 threaded bar or like ive done a 5" long m6 coach bolt.. my washers were also too wide but i just stuck them on the bolt, put it all in the cordless drill and sanded them down with 80 grit till it brought it down to the ID of the 22mm pipe, about 20mm..

stuck the long nut on for tightening and the smaller ones just to hold it still, ive used a hole punch on the two end nuts to stop them moving after tightening them both together..

steel washers are 15mm OD and 6mm ID though ive used two different sizes upto the rubber washers im going to make another one with the right size steel washers.. i got all the bits from a local diy store and the pipe sleeve from B&Q which is 8 OD & 6 ID but its aluminum and i think it might be starting to flair as its all tightened up so might change it for some steel tube..

those jet swets are good for 5 bar apparently and mine holds back mains but im not even sure what sort of pressure i have, i only plan on capping the F&E for the power flush because im cheap and not willing to stick a valve on the 22..

 

[newcastle phill]

Would make a class plumbers weapon.

If rambo was a plumber lol.

Just imagine that coming at you at 8 bar lol