Discuss Connecting up a Victoria Plum vanity unit in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
113
My daughter and son in law recently bought several vanity units from Victoria Plum or Victorian Plumbing. To make things easier they also bought the traps and pop up wastes.The first problem I had was the outlet from the trap was too small to take a standard 32mm waste pipe, I therefore bought some traps from Screwfix which solved that problem but I then found that the Screwfix traps would not tighten up on to the pop up waste, they would tighten so far but then pop off the thread. I therefore bought some pop up wastes from Screwfix and all fitted OK . I have since found out that I could have fitted a McAlpine EU to UK adaptors to the bottom of their pop up waste which would have enabled me to fit to the Screwfix trap. They are obviously supplying EU fittings without any advice about their compatibility to UK fittings and my questions are 'why do they do this' and 'how was I supposed to fit a standard 32mm waste pipe to the trap they supplied when the outlet to the trap was just not large enough to take it'. I would be grateful for any views/ comments on this.
 
A lot of it will come down to no plumbing knowledge. They are in sales not installation, additionally I’d imagine there is an element of not caring. They probably work on the assumption that the installer will know how to get round it.
 
Wouldn't you think that they would provide an adapter because everybody that buys one of their 32mm traps must come up against the same problem. I am a reasonably competent diyer who will have a go at most things ( except central heating boilers ) but I still don't know exactly what I could have used to overcome the problem.
 
I am a manager of a plumbers merchants. We deal with both installers, diy'ers and retail on a daily basis with the same problems non compatible fittings. Some of the traps will take a McAlpine Eu to UK adaptor rubber to the outlet on the trap.
We used to be a couple of hundred yards from a Bath store and were there unofficial customer service counter.
We get people in who get the hump with us because we don't stock the parts to fit parts bought via the Internet. Most of the products are a pile of crap.
 
I originally started this thread to try and find out just how I was supposed to connect a standard 32mm push fit waste pipe to a Victoria Plum trap where the outlet was too small to take the pipe. All the replies have been very interesting but none of them answered my question. Does anybody have the answer please.
 
The answer is above back to suppliers for an adapter if they don't do one change the trap for a uk one
 
The answer is above back to suppliers for an adapter if they don't do one change the trap for a uk one
I changed the trap for a uk one but then had to change the waste also as the new trap wouldn't tighten on to it. I later found out I could have used a McAlpine EU to UK adaptor to connect the UK trap to the VP waste outlet. I still don't know how VP expect you to connect a 32mm standard waste pipe to their trap which has an outlet which is too small to take it.
 

Reply to Connecting up a Victoria Plum vanity unit in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock