C
CCN1 Assessor
I have yet to see boiler M.I's that state you MUST use a FGA on a new install. I do it anyway cos thats the kind of guy I am.
Personally I think the guy is guilty of negligence but tbh, I think he was unfortunate and the guilt he will suffer for the rest of his life is punishment he will never forget. I think if you don't feel bad for the guy there's something wrong.
It's pretty easy to persecute someone from your comfy chair in your assessment centre, if you really ARE what you say you are.
Sent from my iPad using Tapatalk HD
From Alpha InTec C & X manual, it is on their website if you still don't believe it.
5.6 CHECK THE BURNER PRESSURES - Figs. 26 and 27
Press and hold in the reset button for eight seconds and the boiler will fire at a fixed output depending on the position of theboiler central heating thermostat knob.Turn the boiler central heating thermostat to maximum to check the maximum central heating burner pressure.With the boiler central heating thermostat set to maximum fully open a hot tap to check the maximum domestic hot waterburner pressure. In this mode the inlet gas supply pressure and CO/CO
2 ratio can be checked. Refer to Technical Data, Section 2.1 and 2.2 for the required differential burner pressure values.
Note: The burner pressure settings have been factory set and should not require adjusting.
Last edited by a moderator: