baxi duotec

[mickie]

Hi, another baxi question, fitted an A rated grundfos pump, boiler was working fine but now and again after fitting this pump i get E168, tried on setting 1 and 2, still randomly get this error.. once i reset its back to normal... Dont they like the lower Wattage ?

The other change is balancing the system and as the 9 rads that are in this house are small, they're turned down a lot, currently on 15c difference at the boiler return..

 

[Subby]

Why are you fitting a pump to a duotec? They already have a pump inside

 

[Billy Bob Bob]

E168 is normally a pcb issue,have you fitted a different pump?

 

[mickie]

Yeah ive fitted a different pump, ups2, to save energy and reduce the pump speed as it was too loud imo, this is for my house, normally id not care..

 

[mickie]

Why are you fitting a pump to a duotec? They already have a pump inside

the old pump runs on max speed, so i swapped the pump head for an ups2 so lower the speed and save on energy..

 

[Billy Bob Bob]

Yeah ive fitted a different pump, ups2, to save energy and reduce the pump speed as it was too loud imo, this is for my house, normally id not care..

That will be your problem,feedback from the pump is killing your pcb ,it will eventually totally fail

 

[mickie]

That's a tad annoying, the old pump running flat out was getting pretty annoying..

What about fitting an older style pump i can reduce the speed on and taking the ups2 out ?

 

[ShaunCorbs]

That's a tad annoying, the old pump running flat out was getting pretty annoying..

What about fitting an older style pump i can reduce the speed on and taking the ups2 out ?

cant you stick in an old 3 speed non erp pump? the ones with a lever on the side

 

[mickie]

Yeah thats what im thinking, it should be ok ?

 

[ShaunCorbs]

Yeah thats what im thinking, it should be ok ?

If it took a stnd pump should be fine with that

 

[Chalked]

The pump may look the same. But different boilers have thier own impellers to suit flow for boiler.

 

[mickie]

They're all still grundfos, i normally eye them up before swapping them round.. be interesting to know why the erp pump doesnt work with the pcb.. can i not fit the newer duotec erp pump to the older boiler ? and the pcb to go with it ?

 

[Last Plumber]

Why not fit a low loss header and the original pump ?
Plus a smaller external

 

[Gasmk1]

we were told at baxi that eventually the boilers would be obsolete with standard pumps as they will not work with erp pumps so the amapage draw must affect the pcb

 

[Stoney Ground]

we were told at baxi that eventually the boilers would be obsolete with standard pumps as they will not work with erp pumps so the amapage draw must affect the pcb

Main reason WB changed the Junior I, was the fact they could not get it to run on erp pump.