You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
drayton
Drayton is a rural locality in the Toowoomba Region, Queensland, Australia. In the 2016 census, Drayton had a population of 1,710 people.Drayton is at the outer southwestern edge of Toowoomba. It was first substantial settlement on the Darling Downs, initially being established in 1842. The nearby township of Toowoomba expanded more rapidly than Drayton, and in the 1860s the centre of population shifted to Toowoomba, leaving Drayton as a southwestern suburb.
My Mid Position Valve has been playing up for years.. But a little tap, jet of air, or some lube seems to sort it.
This year its failing more often than working, so its time to change it.. I have sourced a new value and was surprised to see that it had a black button on the side of the...
My CH/HW is controlled with a Drayton LP241 (Which is rebranded as Iflo as I replaced it a few years back due to a fault).
Its been fine for years but last weekend I 'boosted' the water and the boiler didn't fire.. I then looked (listened actually) to the programmer and it was acting strange...
Am thinking of installing one of these systems. Am undecided regards using the smart TRVs. I like the idea of them being controlled by Google Alexa, if it
actually does work well. Does anyone have actual experience of this setup using Google?
Hi all,
Been researching to see if I can install a Nest 3rd generation control myself. I have opened up my existing Drayton Digistat and discovered the L is hooked up to 1 and I don't seem to have an earth. The system works with my wall thermostat calling the receiver, but I am just confused...
Hi,
I am planning to upgrade my current boiler programmer to the Drayton Wiser system. But after reading a lot on the internet, I am still very lost about a couple of things. My boiler is a system boiler with a hot water tank.
Question 1
If all the room thermostats and TRV thermostats are NOT...
Hi Can anyone help with this please? Not sure this thermostat is working properly. I turned it on this morning and temp in room was 21....thermostat set to 23 and heating came on but after only about a minute or 2 it went off!!! I then turned it up to 25 and it then stayed on but obviously...
This probably applies to other systems to but here goes. I've always understood that a roomstat will switch off the boiler when the temperature in the room will reach the set temp on the stat.
Now with the new smart wireless systems you get a roomstat and so many radiator stats. So if you have...
Anyone have experience of this setup. Im looking to get a smart arrangement and this looks good and not badly priced and like some others works with Amazon Alexa?
Hi folks
I am in the process of replacing a standard 3wire room thermostat with a Drayton RF601 device.
My question relates to the wiring of this device.
The old room thermostat had N, L & Switched Live return.
The new device uses N, Permanent L, Common and Switched Live return.
Obviously the...
Finishing off an install in the morning, replaced wiring center and programmer.
Am I right in thinking there is no need for an MT10 mechanical clock? When I was picking up my bits someone said just stick an mt10 on, I picked one up just in case but don't see the point in it if I have the ch...
Hi All,
I've bought a replacement for a Drayton Tempest Three. The old back plate is slightly larger than the new on on the Drayton tempest 7.
Ive included some pictures below. The black plate is from the old tempest three which shows the wiring as it currently is. I've also included a picture...
Hi All,
I've got a Drayton tempest three control panel that must over 20yrs old. It now needs changing. can anyone tell me how you get the panel off so I can get access to the wiring? There's no screws around the side or obvious clips anywhere.
Thanks
Hello Everyone I've just joined the site and hope someone can help a plumber in need.
Not been on forums before so this is all pretty new to me, if the thread is in the wrong place then apologise.
I got called out to a customers house last week as the central heating wasn't working, on...
Hi,
Our Drayton Heating controller (LP522SI) has stopped working and is continually rebooting itself with a P15 error code. When it is outwith the programmed operating times it doesn't 'reboot' and shows the time, i can move to the options off/time/once but it will not go to ON on either Heating...
I think the actuator on our MA1/679 is faulty/sticking, but am not sure how to get it off to replace it. It was fitted so that it is touching one of the pressure vessels. The leaflet left by the plumber doesn't really help.( I tried to post a link to a pdf of it here, but the forum doesn't...
do drayton have reducers to fit the older style tvr head valves?
i have a customer with an 8 bed property with 28 rads to an aga and 1920's heating system so dont want to drain down to change the heads as my insurance dosnt go as high as the parquetry floors in the house or the patience in...
I have a radiator with old Westherm Four TRV which is going to have a settee close in front of it. It seems that replacing the TRV (head only if possible) with one which has a remote temperature sensor and adjuster would be good in terms of temperature control, and also access to adjuster...
I have an old heatslave boiler and the diverter valve gears have worn away. I want to replace it before I replace my boiler in the summer. Been told by local merchant that my model, A679B316-52L0 is dicountinued. I looked at another Drayton diverter valve and the connections are male not female...
Drayton Digistat +3RF Room Thermostat
Moved into a house a few months back.
The heating setup is controlled by a Drayton Digistat +3RF and a wireless reciever in the boiler room.
Few issues:
Temp reading on the digistat doesnt always appear to be correct.
Heating comes on at random times...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.