- Messages
- 526
while cutting the end of a ball valve i woundered if anyone on here had a great way of fixing cross threaded threads
Discuss Cross threading nylon thread in the Plumbing Jobs | The Job-board area at PlumbersForums.net
And if your joining on with. Flexi you won't have to do any pipe work adjustment.!
If you have to cut the tail of a ball valve leave the jamb nut on when you cut it then wind the nut back and forth over the cut edge. That will line the threads up.
To join back on to it without faffing about wasting time getting a flat edge, leave a jamb nut on it and use a female adaptor and seal it with the jamb nut like a long screw.
Yes, but use an extra jamb nut/back nut on top of the female adaptor to seal it.ah hold on. is the jamb nut the ball-valve nut on the outside of the cistern?
Reply to Cross threading nylon thread in the Plumbing Jobs | The Job-board area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.