Discuss Thermostat setting in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
2
Hi

How can I set me water tank thermostat correctly so it is using the cheapest tariff of electric . I have attached a picture ... thanks
BC1549DC-73AE-4038-A275-29F41BA996CA.jpeg
 
Hi

How can I set me water tank thermostat correctly so it is using the cheapest tariff of electric . I have attached a picture . thanks View attachment 40153
See page 26 of the instructions:

The little white sliders (tappets) round the outside of the clock dial need to be pushed inwards around the dial (off)for the daytime hours, leaving them in the outward position (on) only during your cheap rate period (whatever that is, say 12.00pm till 6.00am)

At the moment it seems to be on all the time.
 
See page 26 of the instructions:

The little white sliders (tappets) round the outside of the clock dial need to be pushed inwards around the dial (off)for the daytime hours, leaving them in the outward position (on) only during your cheap rate period (whatever that is, say 12.00pm till 6.00am)

At the moment it seems to be on all the time.
Thank you very much !! Problem solved
 
Yes agreed , most think its cheaper at night , especially when a programmer says “ off peak “ .
Couple of years back I had a quote from Scottish Power, and their prices were 12.363p day, 5.31p night. They based the quote on 55% of usage at night, when even if hourly use was same round the clock (unlikely) it would be less than 30%. Clearly a try-on to reel me in by getting the apparent cost down. I didn't buy.
 
I have just fitted this on a economy 7 system, set to 12.00am - 7.00am I would employ a engineer to check you have economy 7 and the immersion heater is connected to the off peak board , as this one was wired wrong. Kop
 

Attachments

  • IMG_20190828_153830.jpg
    IMG_20190828_153830.jpg
    1.2 MB · Views: 9

Reply to Thermostat setting in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top