I need to adjust the large flush button because water continues to run after the cistern has filled up and the button does not return to its proper position, it stays depressed. The small flush button is working OK.
In which direction does the dual flush operating plate need to slide/be moved?
Which buttons do I press to pair a wireless Danfoss TP5000 si thermostat with its receiver? The receiver is a Danfoss RX1, with a PROG button and a CH1 button. The manual doesn't mention pairing.
Danfoss technical support confirmed that the new cables could affect the signal and recommended fresh batteries and move the thermostat nearer the boiler. The batteries were fresh so I moved the thermostat and that cured the problem. Although a 30 metre range is claimed it is more like 10 metres...
We have a one a half bowl sink in a standard 100cm base unit. We want to replace the sink with a new one a half bowl sink in the same worktop. How likely is it that the new sink will fit in the same aperture with little or no cutting?
The batteries are good, Duracell Industrial alkaline. I will do a reset/rebind. It was done about 6 weeks ago when the thermostat was playing up then but I have had the electrical work done since then.
1582318289
I haven't got any LED light bulbs, the only electrical changes recently are the...
The new double oven cable is routed up to the main loft in a two-storey house then through the loft then down through a cupboard on the landing to the ground floor kitchen/double oven. As a rough guess the distance from the cable to the thermostat transmitter varies between 20 and 30 feet at...
I have WB combi boiler controlled by a Danfoss wall-mounted wireless thermostat. I recently had some electrical work done as follows:
1. New mains distribution board in hallway
2. New cable from distribution board to double oven in kitchen
3. New isolation switches to bathroom extractor fan...
That would work for boiler cover but the Danfoss room thermostat packed up this week and was fixed the same day under the service and repair contract which covers the whole system.
The taps look like this but are a different make: Victoria Traditional Basin Taps | Buy item at Victorian Plumbing.co.uk - https://www.victorianplumbing.co.uk/victoria-traditional-basin-taps
Even though I keep tightening the handles up as tight as I dare without stripping the threads in either...
The bathroom walls have got plywood sheets on wooden battens on brick walls, the top half is skimmed over with plaster, the bottom half below a dado rail has got Marbrex waterproof panels over the plywood. The copper pipes protrude through the Marbrex and connect to the valves at the bottom of...
The boiler service isn't due until next April, I haven't got any other plumbing jobs that need doing. Screwfix does a Curved Ladder Towel Radiator 1200 x 600mm Stainless Steel for £350 - that's the size I need. With new valves and rust inhibitor, plus labour and VAT, my estimate is £500. £30 is...
Yes, I have already got one of those, hence my request for an estimate for STAINLESS STEEL. Screwfix have a Reina Curved Ladder Towel Radiator 1200 x 500mm Stainless Steel (28769) for £316.92. But I need a 600mm width. My guess is that I am looking at spending £450 including labour and VAT, but...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.