- Messages
- 5,170
I have the above which was fitted with a 13 amp fuse, which melted the diverter motor wire and blew the fuse on the pcb. Do they have a spare fuse on them or shall I just get a new pcb for it
Discuss baxi 80e circuit board fuse in the Plumbing Jobs | The Job-board area at PlumbersForums.net
not sure about this particular model but often a monument basin spanner works on difficult nuts
Diverter valve motor? On an 80e?
Also, you know when you pull out a temp sensor lead and the little flimsy plastic latch breaks, do you need to replace the whole sensor or does someone have a trick
The HE is a different beast. Any issues with diverters on an Baxi take the side panel off is there is access to the left. Makes your life easier.
The instants can be a right b#stard to work on and make water tight. Check the pressure vessels ok before you leave.
silcone and ptfe tape can sometimes save the day
You might have to try both ways, I've never got them mixed up tbh.
Does anyone carry a selection of small washers for boilers and things For When you take a sensing pipe out and lose the washer or the washer crumbles and then you're stuffed. If so, where do you buy them from and what sizes
Reply to baxi 80e circuit board fuse in the Plumbing Jobs | The Job-board area at PlumbersForums.net