Discuss Sometimes you just need to do what you need to do in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

tamz

Yesterday i was finishing off a wee cloakroom and at the end of the day thought just stick the pan in and thats me.

Not quite............where's my grinder

20160706_170524.jpg

That will do nicely :)

20160706_180129.jpg
 
Tbh it looks good how did it cut ?
 
Asthetics lol
No way was i leaving the pan sat forward and wasting my good work.

What could be viewed as a bodge becomes a noble and artistic effort when you consider you did it solely to avoid budging it forward by the length of another pan connector inside the swan neck.
 
What could be viewed as a bodge becomes a noble and artistic effort when you consider you did it solely to avoid budging it forward by the length of another pan connector inside the swan neck.

I did it to avoid "thats you mrs, you can paint the bit 3x2 jambed down the back of the cistern, You'll get used to looking at it. That will be 1800 pooonds please" lol
 
You do know that someday in the future, some plumber is going to come perhaps to change a fill valve on that, or replace the loo, etc and is going to comment - "Who did this bodge?" :grin:
 
Is the 4" in the floor at a funny angle ?
 
Less than 10º. Dwarf wall below stopping it from being plumb and no room too get a bend in.
You can't notice it now its all sealed in and if you do you need to stop lying down on the toilet floor.

Normally when changing the seat you notice all of it :D
 
Status
Not open for further replies.

Reply to Sometimes you just need to do what you need to do in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top