K
Kuraykin
Hi, I'm buidling a small catapult and thought I'd use PVC pipe as we've a limited weight constraint.
I'm going to use 0.5", and I've been looking at connectors. Ideally I need two double t 45 degree connectors I've seen reference to double wye? And four triple 90 degree based connectors with a 45 degree angle coming out of them (two left-handed and two right-handed) if that's the correct term. I could always a 3-way corner connectorhen attach 45 degree elbow to each of them but wondered if this type of connector was available.
Essentially I'm trying to build two A-frames (with a vertical central strut that goes from the base, to above the top of the "A") connected at either end of a recangular base.
Is there a good website for the various connectors? I've mainly found american based ones. I'm based around Sheffield for the next week, but will be Coventry for Easter and don't need them right away.
I'm going to use 0.5", and I've been looking at connectors. Ideally I need two double t 45 degree connectors I've seen reference to double wye? And four triple 90 degree based connectors with a 45 degree angle coming out of them (two left-handed and two right-handed) if that's the correct term. I could always a 3-way corner connectorhen attach 45 degree elbow to each of them but wondered if this type of connector was available.
Essentially I'm trying to build two A-frames (with a vertical central strut that goes from the base, to above the top of the "A") connected at either end of a recangular base.
Is there a good website for the various connectors? I've mainly found american based ones. I'm based around Sheffield for the next week, but will be Coventry for Easter and don't need them right away.
