Loctite 577 opinions?

[JTplumbingservices]

Anybody use this?
If so what do you use it on most and what’s the verdict ?
Just bought myself a bottle.
Pricier than I expected

 

[Riley]

Brilliant from memory I think @ShaunCorbs Told me it can be used on any metal thread as long as it’s clean

 

[ShaunCorbs]

It’s brilliant it might be expensive but it’s guaranteed first time I’ve never had a problem and can be removed easily

 

[JTplumbingservices]

It’s brilliant it might be expensive but it’s guaranteed first time I’ve never had a problem and can be removed easily

So would it be suitable for example for screwing a bayonet fitting into a wall plate elbow ?

 

[ShaunCorbs]

Yes

 

[Harvest Fields]

I have just started to use it and love it.

 

[JTplumbingservices]

I have just started use it and love it.

I just used it there, it’s done the job.
£20 a bottle or 40p for a roll of tape though
I’ll see how long it lasts me.

 

[Harvest Fields]

The only bad thing is once set. If you crack the fitting. That whole fitting has to be done again.

 

[JTplumbingservices]

The only bad thing is once set. If you crack the fitting. That whole fitting has to be done again.

How long does it take to set ?

 

[ShaunCorbs]

It’s gas tight instantly but if you want it at a special angle normally an hour to be hard

 

[Harvest Fields]

It says cure time is 1/3 hours. But I have been told you can get an activator that speeds that up

I haven’t used it on gas yet.

 

[quality]

Ive used it for over 20 year and not had one failed joint. Instant low pressure seal on gas

 

[Chalked]

Haven’t used anything else for 3 years.

 

[Riley]

It is a bit scary at first

 

[Riley]

Popping your cherry is an ordeal

 

[Sharp Point]

Numpty question, as I’ve never used it... could you use it on 1/2 rad tails straight into a cast iron radiator?

 

[Harvest Fields]

Numpty question, as I’ve never used it... could you use it on 1/2 rad tails straight into a cast iron radiator?

As far as I am aware yes.
Up to 2” I believe

 

[Sharp Point]

As far as I am aware yes.
Up to 2” I believe

On a sealed system too HF?

 

[Harvest Fields]

On a sealed system too HF?

I think it does upto 10 bar but not 100% sure

 

[Sharp Point]

I think it does upto 10 bar but not 100% sure

Mmmmmm, that’s good to know. I’m currently doing a job, where I’ve got lots and lots of repro cast iron rads with polished brass valves. I would’ve boss white and hemped the threads

 

[Harvest Fields]

Mmmmmm, that’s good to know. I’m currently doing a job, where I’ve got lots and lots of repro cast iron rads with polished brass valves. I would’ve boss white and hemped the threads

The cure time is about 3 hours. Just so you know and once the joints are set if adjusted need to be sealed again.

 

[quality]

Numpty question, as I’ve never used it... could you use it on 1/2 rad tails straight into a cast iron radiator?

no problem

 

[quality]

On a sealed system too HF?

Ive used it ob 1 1/4 bsp at 110 bar