fluctuating inlet pressure

[mutley racers]

I have a 24 kw ecotec pro on a 22 mm 8 metre run on it which has fluctuating inlet pressure. Goes from 18mb and then suddenly drops down to 10 and back up again. It has a cooker and fire connected onto it after this section but it is the same with and without them on it. All fine at the meter 19mb working pressure steady.

 

[Ermintrude]

Cornflakes or water in supply pipe . Open up gas cock under boiler out some white loo roll over and give it a few blasts. Also check gauze filter on gas valve

 

[mutley racers]

Cornflakes or water in supply pipe . Open up gas cock under boiler out some white loo roll over and give it a few blasts. Also check gauze filter on gas valve

I did open up the end of the gas pipe and didn't see anything pop out but when connected all up again I got it steady on 18 mb and dropping to 16. So I guess it must have been that a.

 

[Billy Bob Bob]

I did open up the end of the gas pipe and didn't see anything pop out but when connected all up again I got it steady on 18 mb and dropping to 16. So I guess it must have been that a.

possibly govoner on the meter failing,diaphragm or spring going weak start with the meter get the ESP to change the govoner

 

[mutley racers]

possibly govoner on the meter failing,diaphragm or spring going weak start with the meter get the ESP to change the govoner

even if it's not jumping about at the meter?

 

[newcastle phill]

Just curious. Whats the Kw of the cooker and fire. And their respective lengths

 

[Ermintrude]

Fire. 7kw cooker 5kw at a guess

 

[mutley racers]

Just curious. Whats the Kw of the cooker and fire. And their respective lengths

Yeah standard really. 6.5 and 7 kw and not that long. But, the inlet pressure was doing the same thing with those 2 appliances turned off.